The solution to my problem was I had to physically log in to the keypad using a Master account, this then allowed the Cloud upgrade to continue.
Also, it needs to be a "proper" master account - not sure exactly how to define this but my Master account had been modified to change its permissions...
It happened soldering joints in the pipes visible just below the offending areas.
The hole is right next to a roofing lath, meaning a fix could be very involved?
Obviously I'm annoyed this has happened, how much of a problem is it? I'm sure the company will try and get out of it, whats an...
I recently had some work done in the loft and the workmen managed to burn a hole through the membrane under the tiles, and scorch another area.
What is the appropriate fix for this?
They've agreed to "do something" about it, but I'd be grateful of your insights to ensure its fixed properly...
@terryplumb @oldbutnotdead Thanks for the insight and help.
The programmer on the wall controls the topmost valve, which goes to FLOW on the tank.
I've now found the radiator thermostat control, this is the lower valve (pipe labelled HTG)
The UFH manifold is behind a cupboard full of stuff...
@oldbutnotdead thanks for the reply.
Combi pic attached.
I'll do the tap-test as you describe, good iea.
Re pattress, I've taken that lid off - I'm trying to determine which thermostat is controlling what as it's currently a confusing mystery that doesn't work as I'd expect.
I've moved house and I'm trying to understand what's going on with the plumbing.
I have a combi boiler and then the below system for central heating and under floor heating. However this cylinder is turned off electrically but is hot, so is this fed from the combi? Is this tank just storage for...
I have a Premier Elite 64 running on V5.00.03 LS1 Firmware and I'm trying to update it to the latest v5.06.00 LS1.
I have access to an Engineers/Installer's Texecom Cloud account, and via that when I goto Site Overview and choose Panel -> Upgrade Firmware, choose the new firmware and go to...
Hi,
I'm installing a wood burning stove in to my living room at the same time as applying insulated plaster board to my external walls.
The stove I'm fitting has a "combustibles" minimum distance of 450mm, and I've read (plenty of threads on here) that you shouldn't use anything gypsum...