i have a ravenheat combi boiler, it has been fitted over a year but only been on a few times but quite often when it is used it starts to make gurgling and clanging noises and i can hear air bubble like noises coming from the boiler, the noises are quite loud like boiler is really struggling but...
i have got to repaint a buildings interior, ceilings white, walls to be filled and painted magnolia and the woodwork with white gloss, in what order is it best to do these jobs and any other tips welcome, thanks
can i fit a solar light in a porch,the porch has a pitched roof so the light can only enter through the windows and was wondering if the solar light panel would still be able to pick this up and recharge itself, thanks
i am looking to buy some new painting gear for diy but i am fed up with cheap sleeves that leave bits everywhere i paint, can anyone recommend what the best type roller and brushes to buy for diy but a good set, thanks
i have had the same problem and done the cheapest thing first, fit an air vent to chimney breast inside room and if exterior of breast is in an entry or outer wall fit an air brick in to allow chimney to let air flow instead of moisture and damp to be trapped.
do i need planning permission for concrete block shed built from 4" concrete blocks, the size will be 15ftx7ft and will be 7ft high and is at bottom of garden about 30ft from house.
i have just bought a new 24 volt bosch cordless drill and have charged it up and when i pull trigger in quick spurts there is sparks inside where the motor is, the sparks are brighter when the drill is on forward than when on reverse, i was thinking it might go away with use but then again...
what is the best way to fill holes and dents in plaster ready for it to be wallpapered over some of the holes and dents are over half an inch in depth, should i do it with poly filler in layers and also some big pieces of skim has come off about 12 inches square and about 3mm in depth can i use...