Recent content by wedgy3

Can anyone advise where I can find a sink & matching WC for a small cloakroom - we need a sink bown with a max 250mm projection from the wall.Thanks

Thanks guys - looks like a poor choise made by the signifiiicant other :(

Is there any way to "remove" / polish out hairline scratches on gloss finish worktops - black in colour which makes it even worse.

Can anyone tell me where I can purchase a 6 gang grid plate cover in S/Steel or crome?

Thanks for the detailed advice ( mandate ) we bled the air from the vent next to HW tank & the system works a treat.MANY THANKS

Her partner fitted the rad.Prior to this they had intermittant probs with the boiler not fireing but this has now got much worse??

Is there a simple way to check to output of my daughters pump.They have an Ideal Classic boiler,the flow to the 3 way valve was cold untill I put the pump to number 3.The flow is now hot & so are the outlets to tank & Rads,the hot water is hot but the rads are cold.The boiler only fires for 20 /...

Thanks - I like the 12 gauge screw idea,Ill deff try that

I am levering from the end of the skirting to prevent damage to the plasterwork above.Its nailed with 80mm nails which are solid into the blocks.I just had a vision that someone "must" have invented a tool to remove the bottom edge of the boards without having to remove them.

Does any one know of a good way to remove skirtings which are nailed through plasterboard into blocks.I have removed a small section but this causes damage to the plasterwork.The reason for removal is to install laminate flooring - is there a router which could remove the bottom12mm of the...

I have the instructions & they are straightforward enough - my problem is that I an not corgi Reg.I am an electrical Eng for my sins.I may have to do the job myself & get a fitter to examine the fire afterwards ??

Yes I have replaced the batts in the remote & the 6 X AA batts in the fire its self.I think nickso has the right idea.The guy I spoke to at Crystal fires refused to recomend a corgi fitter? I don't want to send for someone who may know less that I do - I need someone who is familiar with this...

I dont think I have explained myself correctly - The pilot flame works OK.I am familiar with the instructions & the remote operates OK intermittantly!! The "clicking" noise is not the spark & I am sure its from the motor its self.

I have a Crystal Lagoon remote control gas fire.When I operate the remote there is occasionally a "clicking" noise coming from the motorised valve area,when this happens there is no responce.Has anyone any ideas or knows of a reliable engineer who is familiar with this set up?