Recent content by wrighty208

Thanks guys, there is an earth bonding - it just wasn't in the original photo. Will they charge me to change the bracket/fit the adapter or should it be free? Do I call Transco or the supplier e.g. Scottish Power? Cheers

thanks for all the replies! Made me laugh this morning - there is obviously some conflicting thoughts... I take it from the comments there is a white plastic clip I can get to fix the pipe to the wall bracket but having said that, the meter is supported by the pipe so no major issue. Hope...

Hi, I was just looking at my gas meter and noticed the right hand side appears to be hanging loose. Can you tell me:- - is anything wrong with this picture? - what is needed to correct it (if not correct already) - whose responsibility is it? (mine?) A few months ago I had a new...

Hi all, My mum's 1910 house has a single story kitchen at the rear. A few months ago, due damp smells in cupboards she had a builder inject a damp course into the wall (9" wall without cavity). Since then, the paint has flaked off BELOW the DPC - see photo. It seems to be getting worse...

Hi all, QQ - just wondering what others do when wiring up a Megaflo wiring centre, do you wire the Neutrals to the 3 x dedicated connector blocks below the strip or do you wire into the strip as per the wiring diagrams (ie 5, 6, 7 and 8 in Megaflow manual) Cheers

Thanks for the response. I believe the system is configured as S-Plan Plus (I have 3 motorised valves for HW, CH and underfloor heating). I checked with Worster Bosch this morning and they said I should still have a separate bypass valve fitted, is this correct? If so I'll get on to my...

Hi, quick question... I have just had a new Worcester Bosch 30CDi System boiler and Megaflo Eco 210i installed in my loft (by a local G3 installer). I don't know much about these systems but am doing a lot of reading up to get familiar with how it all works. So my question is, should...

nothing else giving off moisture - I have emptied both sheds completely for the time being. I was thinking about give the whole base (in and out) another coat of concrete sealer (from Wickes) and then giving it a paint with some garage paint on the inside. This should seal off the inside, I...

unfortunetely it's a metal shed without a base, the frame is bolted down to the concrete base. The base has sand, cement, balast for most of the depth (about 4" approx) and the remaining approx 2" is sand/cement/water. I think the problem is the top layer of sand/cement is absorbing the...

Hi all, Hope I have this in the correct forum.....I have water entering my sheds through the concrete and causing condensation. I have a concrete base in my garden with 2 x 10'x8' metal sheds on. The base is approx 14' x 22' with the sheds at each end facing each other. I have sealed...