Where would it need, or even want to go at 45 degrees?
Running An Electrical Cable Along An Outside Wall
- Thread starter John Peden
- Start date
Where would it need, or even want to go at 45 degrees?
Sponsored Links
Exactly, you can't say "I wouldn't do 'something' because someone didn't do that before".
- Joined
- 17 Aug 2010
- Messages
- 2,741
- Reaction score
- 453
- Country
As far as I'm concerned there is no point in making up your own different rules and then expecting that everyone else has also followed your version.
I've seen the consequence of that. A 'professional' electrician who connected two sockets in a kitchen which were a foot apart, by channeling them both up to the floor above, because he didn't believe in horizontal runs himself.
- Joined
- 26 Aug 2016
- Messages
- 6,833
- Reaction score
- 1,010
- Country
Safe zones are for buried cables, not ones visible on outside walls or otherwise.
It's fine to go via outside although you would rather avoid it. Make sure the cable is supported properly, and protected from uv, any polystyrene thermal insulation, and mechanical damage. That would be either suitable conduit or suitable cable, or a combination.
It's fine to go via outside although you would rather avoid it. Make sure the cable is supported properly, and protected from uv, any polystyrene thermal insulation, and mechanical damage. That would be either suitable conduit or suitable cable, or a combination.
Sponsored Links
I've no objection to horizontal runs so long as the sockets are on the same wall, it's the going round corners I would avoid.
Just for the record, I'm not a professional electrician though I did pass my G&G in the mid 70's and also the 14th edition of the regs. Instead of going into house wiring I finished my apprenticeship in armature winding/electrical fitting though did do a small number of house rewires in my younger days. Last month, just because I was bored being off work for over 6 weeks I sat the 18th edition and passed with 87% which I consider not bad after a 40+ year gap.
Really don't know what corners have to do with anything. A socket on wall X gives a horizontal safe zone for the full width of the wall.
A socket on wall Y gives a safe zone for the full width of its wall.
If the two walls happen to meet forming a 'corner', then so be it. They're effectively two separate entities.
Run it outside through some conduit, not particularly attractive but may be your only option without making a mess.
OK, the spark came last week and there was no need for any external cable.
The dishwasher sits directly under where I wanted the new socket to go and that entire wall turned out to be plasterboard. Dead easy in the end.
For the outside socket, he drilled through the wall and mounted the external socket at the exact same height, just on the outside wall.
All-in-all, pretty straightforward.
The dishwasher sits directly under where I wanted the new socket to go and that entire wall turned out to be plasterboard. Dead easy in the end.
For the outside socket, he drilled through the wall and mounted the external socket at the exact same height, just on the outside wall.
All-in-all, pretty straightforward.
- Joined
- 11 Jan 2004
- Messages
- 42,733
- Reaction score
- 2,633
- Country
I've run outside like that before and used mineral.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
