Totally agree. I’m thinking there maybe a restriction in the cwsc outlet, or even a faulty float valve - depending on when the bath is ran. We use hot water all day and bath the kids at nighttime.
How do I clean feeder pipe to hot water tap?
- Thread starter MoonMan2
- Start date
Totally agree. I’m thinking there maybe a restriction in the cwsc outlet, or even a faulty float valve - depending on when the bath is ran. We use hot water all day and bath the kids at nighttime.
Sponsored Links
Bath taps should be 3/4", although the supplies can be reduced down to 1/", depending on setup. If fed from gravity supply, I'd expect the pipework to be run in 22mm from cylinder/cistern to taps, otherwise if mains/unvented cylinder or Combi boiler then both supplies in 15mm should suffice.
- Joined
- 8 May 2017
- Messages
- 9,411
- Reaction score
- 2,342
- Country
What do you think is 1/2 inch ?
The supply pipe ? ( possible )
The thread of the tap tail ( not likely )?
You have told us that the hot water is gravity fed ,is the cold to the bath tap also tank fed or from the mains ? And how does the cold flow compare to the hot on bath tap ?
Sponsored Links
I bet a bit of foam from the hot water cylinder is in the 22mm section of pipe work.
Andy
Andy
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
