Search results

Foooooking thing I've got 75mm under the tray maximum and the hole in the tray is 50mm Any ideas what I can use? Do wirquin do the smaller ones?

How much and what is there number please? Thanks

It's neither of them Jeff There's a leak somewhere Flue not sealed Hob not right No sleeving on gas pipe Ill price to fix that lot but can't go ripping floors up I suppose ! Would you report this lot or just crack on and charge accordingly ?

ha ha It cost them a fortune by the looks of it also the fused spur feeds the cooker then there is a cable that goes to the hob?

Gas meter was capped by NG - apparently swapped a pre pay for normal meter took cap out and put test on. 10mb down to 0mb in 20 seconds. Put cap back in The house has been done up quite nicely but what is this lot? tenant due to move in thursday. No books or fook all in sight, has the...

Agile - dont always get a reply mate yes i am registered

pump on 3 new 3 port valve

heat only boiler 6 radiators cylinder 3 port valve call for heating and hot water - water only warm and downstairs rads cold at the bottom put hot water on its own - red hot put heating on its own - red hot

U didnt... but i did

love this post :D mbga9pgf hahahahahhaha im HETAS and Gas Safe, i just fire the stoves in, dont give certificates or alarms or anything. i even fitted a stove upside down yesterday as thats what the customer wanted so i just did it, bugger the regs as long as customer happy and paid...

have a look at putting a filter on the heating system that will help your system out a bit

If your radiators are sludged up, (bottom middle of rads are cold) you will need it powerflushed and dislodging merely draining down and re fillling will not get rid of the sludge if your system was powerflushed and treated correctly you shouldnt have any problem, unfortunately a high...

Are there any joints that you can see?

will check in morning when back. thanks

think its 3 bar will have to double check or i could be making that up. what if i took the vented tap off put normal one on and put the pressure reducing valve to 1 bar with a PRV set to 2.5 bar?

ok big **** Thats why i asked... hardly waste of time. So it can't be done with an expansion vessel non return valve etc etc?

Well it will be a normal tap, wont need venting with one already on system. Thats what i did think but is there a way around it? obviously if i connect the two cold pipes together then water will just come out of vented tap hmmmm Heeeelp lol

There is an underink water heater which has a vented tap off it..... I want to add another hot water tap on the wall behind, can this be done? The valve on the hot tap has cold mains to bottom of the valve then cold to the heater then hot in from the heater then upto tap.... Can i add...

Thanks. Shsll I cut thrm tees out then and start again? Why wud it go up vent pipr if blockef though? Flows through heating and cylinder ok? Return off cylinder is 15m A gas man has put all this in! That filter will be doing bugger all and reckon he just thought fuk it to much hassle to do...

Ive attached a couple of images of some pipework in the airing cupboard for a job ive just been asked about. Basically she had a boiler installed last december and shes had loads of problems, banging noises from boiler etc etc.... basically i think she has been ripped off. told she needed new...