Search results

but bg engineers must have the right ppe ie bump cap or hard hat.

ok now we know the make of boiler.which is probely the best modal ideal ever made forget the display & board issue. still recamend engineer inspect it though. how have you confurmed that the con pipe has fully been defrosted

with no display on the ctrl pannel my guess it that water has leaked from the sump and blown the pcb. ? have you got power at the switch. recamend you go on the gassafe website to fond a local engineer.

lol very funny, made me smile, loving this , i see no one will back the wonaby gas man.

this has been a problem since installation, could be possible reverse circulation when running hw feel the cold mains pipe going into the boiler for a rise in temp to confirm

Go to the gassafe web sit to get a qualefied heating engineer to remove the low water pressure switch and clean/replace it. may as well have serviced at the same time.

also with pre heat, if there is a dripping tap, the boiler will come on more often , should be aprox 1.30hr for the pre heat, and about 20 sec to heat hot water storage

an inhibitor is a neutralisar . not a sludge remover. once you have cleaded the system with a quality product such as fernox or sentanel.x800 then you can add an inhibitor.

At the same time you might consider employing an engineer to cemicaly clean the system, look up the gas safe web site. there you will get a list of your closest engineers. bit late in the day though. it will take the plastera half a day to prepaire so you might have time.

£130 sounds about right

you say the dhw runs at a trickle. what flow rate are you getting out your tap and what is the heat diffs between mains in & hot out, should be 35 degrees. also is the dhw turned up to max on the programmer. you should get a GAS SAFE ENGINEER to check the working presure and also service your...

go for the replacment programmer then

Do you have a frost stat .ie is your boiler in the garage

i went to a property the other week ,to a gas leak, the leak was found on the hose caused by a rat this was easy to identify as it was behind a free standing cooker.

oops!!!! 35kw. its only an icos he12 :?

That issssss a lot of ties.

Get the jumper links wrong you could be in trouble mate. Get a gas safe engineer to fit & look the boiler over. best to be safe!!!

you could have a blockage in the cold feed from the small tank, follow the pipe then get a magnet and put on the cold feed aprox 3 inch from where it connects to the system , if you feel resistance then thats where the blockage is. when your rads are working again check for cold spots at the...

i would be expecting 12 to 16 LPM on mains water supply 6 would be very low. poss crushed pipe or stop valve partly shut down.

time to get it serviced it could be the water throttle head dout its the 3 way valve. look up the gas safe web site there you can a qualefied engineer who will fix it and give it a long over due service, easy repair for the pro. remember a boiler needs tlc just like a car from time to time you...