Search results

My 1st landing step is very squeaky It turns out it has limited support under As concrete got milled through out the years What is the fix? See video an picture

thanks, but there still will be air gap, in my understanding , unless insullation layer needs to bee topped up and suppressed ( which is not good) see picture

had some feedback from other people, now not convinced, due to risk of condensation ...... on other hand there are products: like this and even b&Q does something like this

great , thanks

ok so if I understand correclt I will but 100mm PIR boards across rafters ( between them there is 100mm insulation layer) and on top of PIR board I will put loft boards see picture attached

i understand for multi insulation layers, but does this applye for insulations layers and PIR insulation ? I thought gap prevent condensing Thanks in advance for you insights

Thanks so the principal how current pir boards are layed with 6cm gap is fine? if so I will just do the same for the rest of the loft

hello my upstairs bathroom renovation is finished now so time to insulate the loft my rafts are spaced 60cm apart raft height 10cm currently there is 100mm insulation between rafts ( house was build 1990) might replace some of insulation I should be straight forward, putting legs 175mm, 1700mm...

ok,this miracle solved my dilema, only £10

Bought radiator from the Facebook market place it did not come with brackets nor valves thought I will get a standard BUSH 1 X ½"https://www.screwfix.com/p/bush-1-x/42740 , but it turns that the thread on the radiator is anti clock... Does anyone have a idea where to get one, paid £150 so do...

many thanks will try

Happy New Year! long story short, frozen mince caused ceramic kitchen sink cracked/smashed as my kitchen is not a new one,and in a couple years it would need to be replaced wonder if that sink can be repaired,patched etc? if so what filler i needed? many thanks

hello again it all seems to be working now, perhaps after bit of fiddling it seems to work,so for now Im not replacing anything, but THANK YOU all, for great help

so worth replacing both i gues?

thanks again for a great support and help! here is the picture of the actuator and indicator position I have unplugged the 5 pin connector and ran HW only, - still rads where getting worm, however I had that actuator removed from the valve.maybe I should have left it on the valve I tried...

thank you for quick reply!!!!ok.turned ch off on the programmer and ran hw.rads still beeing heated. the green light on bdr was not on. so how do check 3 port valve? thanks again

Hi, I believe I have Y gravity fed central heating system in my house I had Honeywell evohome thermostat with few rad controllers =4 heating zones, and few rads not zoned- it does control my ch but for hot water I use Sunvic Sunpro 2000 2 Channel 7 Day 5/2 Day 24Hr Programmer so in the setting...

got transformer and loom replaced, all working, i feel loom got moisture and burst the fuse, I thing moist/ leak from cartridge caused it, however my hot water valve on inlet pipe overturns and I can not stop the water to replace the cartridge....

thanks this was my fear- I have blown transformer if nothing else so shall I get new transformer, and new loom? then if that works will replace cartridge

hello moved to a house, they had aqualisa aquastream, it was working fine until last night; stopped pumping this morning checked the fuse 3amp, was blown, put the new one in-again -blown, di put 15amp and nothing, fuse ok, but still not pumping Checked if any power comming to the unit from...