Search results

Salt kills most weeds if you give them a good coating. Or if you have time covering them with black plastic and leaving for a season

So you can't be prosecuted and little chance is there of being sued. What is everyone worrying about. It was done all the time years ago and still disconnected today on some of the old cutouts without damaging the seal

The only other thing I can suggest is to contact one of the companies that advertise parts for theie storage heaters and ask them or failing that take them out and if you need to disturb the material you think might be asbestos then dispose of it sepatately using all necasary protaection.

Does anyone know exactly which law makes it illegal?

https://www.diynot.com/diy/threads/berry-magicoal-storage-heaters.333411/ Have you read the other posts linked to below. If they don't help ring the manufacturer

So presumably you can't get fixings into the studs. I would look at something like this...

Is there brick or blocks behind the plasterboard or is it a hollow wall

You could try resetting it...

Yes. And as Wayners said depending on how old it is there may be a lift out bucket type insert that you can pull out and empty. If not just get some marigolds and do it by hand. No need to replace the gully. Cut the grid so that the pipes pass through it. The bathroom one looks like it has...

They do get very tight, jammed even, try a squirt of WD 40 leave to soak and then try one of these in the link...

Our old one used to just blow out of the side of the deck because it never came with a collection mechanism (second hand) so it might be easier to do it that way. It was only a problem when you had a stong wind behind you and the grass cuttings would blow upward faster than you were driving and...

If you had enough of them with batteries it might be ok to run heating and fridge freezer perhaps during power cuts but probably cheaper and easier to buy a generator.

I'm not a professional builder but it looks to me like you have a Catnic lintel above the window, which is, as far as I know, what you would need to build the outer skin on. That is how we did ours and the cavity tray went from the top of the catic and under the bottom of the outer skin. There...

I would tend to doubt that these measurements and the claim in the advert that it is a SAFE working height are untrue

Don't most people seal trickle vents to stop draughts?

I suppose it depends on how safe you feel standing on the platform and how tall you are.

Yes it would seem like you have an elecrical fault which will probably need a visit from a suitably qualified engineer. Have you tried assuhors suggestion. It is detected by a sprung loaded switch which may have stuck.

Have you thought about using hollow wall hangers https://www.screwfix.com/c/screws-nails-fixings/hollow-wall-anchors/cat7280101

So do you mean the upper element does not heat up in single mode? If so does it heat up in the other modes or is it just that you don't get an indication of a fault.

Don't know if that is a common fault or not. Does the brush roll motor indicator light up red, flashing red or green when the brush stops turning. If red then it is being physically obstructed from turning. Flashing red and it is probably an air flow problem. Green and it is probably as you...