Search results

Just replace it ….its not worth messing around with as it’s over 30 years old

No ….cause it probably will use the 2G network to send texts anyway …

You don’t have an aerial by the sound of it …check if there is a cable connected to the aerial input on the booster , it’s quite normal on new builds for the internall cables to be installed but not the tv aerial…

Probably bellbox …I would spend money on a panel that gives the information on what is creating the issues ….

Those brackets will only be any good as long as you can mount the camera at 90 degree to the viewing angle ….and only good if your mounting the camera internally ….

Traveller whiskey NO 40 …..46%……nice !

Ok for a an example….you had a cat 5 cables in your house 1 point per room …x10 that all ran to a common point that hadn’t been labelled up …you clip on the tone generator at room 1 , go to the set of 10 cables , run the probe done each of the ten cables one of these should give you a tone …...

No safe zones in them days …

Think I had a 50 in 1 kit at a guess Tandy ( radio shack ) in the 80s …you used to gat a Tandy diary with the battery club ( you could claim a free battery every month )

That fire alarm is a loop it starts at the fire panel and ends at the panel …everything inc sounders plus other devices are on that loop ( there may be a separate bell circuit aswell which may be a normal EOL circuit …. You need to make sure everything is removed or it may go with a bang if you...

As per manual

You need to speak to galaxy guy …

I think a look at the log in the panel ( from user menu ) may shed some light on it

It’s not just a yes or no ….as not knowing what program options have been set there could be multiple reasons as to what you have described ….there are probably hundreds of variables on the Texecom depending of programming options

Sounds like it didn’t go to full alarm …

I would …. Part set then activate a guard zone and see what happens as it may be the case of a pre alarm and it was turned off before a full activation ? Did you have to reset the alarm ?

Was it part armed ?

Yes

I take there wasn’t spare cores to split down the two detectors

I think that is correct as I had the same issues on a job …that was the answer from tech support….