Search results

Yes i know but using what without buying a stud finder ?

Can anyone tell me the best way to go about securing a cabinet to a stud wall please?

I think i have mastered the thermostat

My thermostat is taking the outside temp from the internet

the outside temp showing on the control was fine all day but on the graph it does not look right at all

Juat as you mention that i had just noticed something. The outdoor temp you can see in this photo is wrong. It was around 15 degrees outside at thst time

I am finding out more on here from others. At least on here i am getting more ideas and i like learning so of you could please ignore my posts and let people who want to help. That would be good.

I found this on worchester bosch website Do I remove the link wire in the boiler when fitting a Worcester control? No, when using Worcester controls the link wire stays in place. The link is to be removed when only using third party controls.

Something i can check myself as long as i dont touch it?

What do you mean a link left in?

Why would my worchester bosch be firing up when it has been sitting 2 degrees above set temp? Its been firing every 10 or 20 mins for around 20 seconds then off again but in this photo it has been on a good 20 mins on now. I have the easycontrol ct 200 thermostat.

Can anyone advise me a good/correct setting for a heat curve specifically but not limited to the wochester bosch greenstar 4000 and the easycontrol ct 200 for a semi detached bungalow with moderate insulation in a uk property?

So i spoke to worchester bosch and they reckon to just leave weather compansate off. They reckon because its not to cold out and i have it turned on it is telling itself to burn low. Kinda defeats the purpose if you ask me tho. You would think it should know to burn a little bit warmer.

Ai explanation If the boiler is still burning gas even after the room has surpassed your "Optimum" target temperature, it usually comes down to how the CT200 handles Modulation versus a simple "Off" command. Here are the three specific reasons why it’s still firing: 1. The "Approaching...

Juat an update it messed about barely coming on to get temp to optimum set temp for 6pm and then it eventually got to temp 45 mins later. And since then the boiler has decided to plough on and now sitting at 22 degrees.

Yes i have done that both not much help

I did that saturday when i was balancing the rads. It got to temp 45 mins after optimum set time. I think its just learning. Thats what i hope.

It did the other day but i decided to leave it incase it confused it if it is in its learning stages and thats why its been like it has

I have optimum start on and it didnt bother to bring it up point 5 of a degree for me for 6pm i know its not alot but it baffles me why it wont do as its told. I am just wondering is it still learning or what

how do i do that?