Search results

With regards to the switch. Does that push the black cap over on the diaphragm?

Ok thanks for all your help. I’ve not missed putting anything back. Also, one thing that did happen is the micro switch got a bit wet when I removed it from valve. Could this have made it short when powered up?

So today I have no hot water not heating side is fine. I have a Worcester 24cdi combi. So after a bit of advice that it’s probably the diaphragm on the diverter valve I set about replacing it. 8 hrs later and wat a b***h of a job that was! Anyway no leaks so I power up and still no hot water! So...

ok thanks. im going to dismantle my existing stairs over the next couple of days and will post back here as to what i find in hope of some help

Did you replace the full newel post or cut and dowel the new ones?

hi skippy i know this post is a bit old now but im doing the same thing as you and your stairs look to have a similar set up to mine. If possible could i pick your brains regarding how to go about this? thanks

Cheers that’s a very informative video

Cheers. I can’t seem to find anywhere online that gives advice on how to tackle it, maybe because it’s not doable!

Ok good point. Unfortunately I need to replace my full newels so I’m looking for any advice on how to tackle that

It would be easier to do as you say but the existing newel post is white gloss and I want to change to solid oak

Hi Clockpie I’ve just posted for some advice on something very similar to what you have done. How come you didn’t change the newels?

I wish to replace my current white glossed stair parts (newels, spindles and hand rails) for solid oak to match recently changed interior doors. Could anyone give me any advice on how to go about this particularly on how to replace the full newel posts. Many Thanks

Thanks mate. Replaced bushes and all good now

Hi Stuart mine is all layed now. Not sure if you’ve done yours yet but let me know if you haven’t and I can give you some advice and tips

hi I have a hoover washing machine model number DYN8164D2X that made a slight grinding noise when spinning and then gave me an error code 08 at the end of the cycle. Had a look on the net and it says Tacometer or Brushes?? Any help?

Thanks John

I wish to change the doors on my kitchen units but where the hinges are screwed to the units have become worn and the screw holes quite burred. Is there any way to repair these so I can get a good solid fix for my new doors? Thanks

I’m looking for advice on a house alarm with an integral voice dialler in case it goes off when I’m out. Would want something that’s reliable and not prone to false alarms Thanks

Thanks again. The slab has been poured today. It will be at least 4 weeks till I can start on the floor. If I apply the dpm does that not stop all moisture coming through to plywood?

Thanks again dazlight. If I measure it with a moisture meter what levels am I looking for?