Search results

It’s not that camera ….

Read the spec sheet I posted …it does support a memory card …you would have to connect that camera to the your network to access the card and set it up …that bnc video output is only probably to assist setting up the camera

This may a long shot ….as you are using SIA format …does it transmit text description to the ARC ? if so are there any non SIA text in any of the descriptors , I’ve had with panels if you put say a / in , it locks up the communications ( dual com ) …

I take you don’t get out much ….seen loads of these fittings around the uk ..

I think ( as I don’t really do wireless on the texecom ) you go to device and press “ reset reset “ to delete it ( off top of my head )

Onto keypad and check zones are all the descriptors back in the panel , exit engineer and check that your original codes are in …

Fit relay 12v dc handy little relay or Paxton relay …12+ to one side of coil the other to bell trigger …

Put into engineering Remove lid Put com lead on com2 Open wintex …choose saved ( original profile ) , select connect by pc com ….does it connect ? It should say at the bottom screen , if not what warnings does it com with ? Check that the UDL is 1234 ( default in wintex ) at the panel in UDL...

Ok ….if it’s defaulted you need to put in the UDL code or it won’t let you download the wintex profile ….what does it say on wintex when you try to connect to panel….also what com port are you plugging onto ? Com1 or Com 2

I can’t see how you have caused this by making one zone not used ? ….what else did you do ? …anyway just reload your profile from wintex it should be ok

do other people in your block have the same fault ?

More like a stuck Reed switch ….

Least it will cover the existing holes

Press chime then 0 …

FFS ….if he can’t get it working on a short bit of cable to a video input …then what’s the chance he can sort it via the IP route …which has many other sidelines / settings to sort

Where do you live ?

What devices do you have ?

Don’t think so maybe the 030 version or possibly the dummy version with a sounder inside

I take it you didn’t bother to read all the thread ? It’s allready been said and it looks like the poster has allready bodged up a lead to connect it !

Problem is …. They did 4 versions Prima 100 no cut off Prima 200 no cut off Prima 300 ….with cut off Prima 500….with cut off ….normally green LEDS Plus a Prima 030 ….single LED ( so it’s not that one ) I would wait till midday then power it down mains and battery and see if the sounder cuts...