Search results

No need to go outside.Just turn the full lever on the left of picture and do as stated above with a piece of copper and two new olives.

I used an electric planer on mine to take the ribs off.A lot of white powdery dust but done the job.

Run a timber around the inside of the wall and screw through into the worktop from underneath.Pre drill the timber to make it easier to fix worktop.

Copied and pasted......Where an extension attaches to a pre-existing outbuilding, the pre-existing outbuilding becomes part of the enlarged, improved or altered dwellinghouse; as such the conditions in A.1 (i) apply, i.e. the resulting extension cannot project by more than 4m from the rear wall...

That bottom diagonal brace would have been better going the same way as the top diagonal.

I have used them many times on that type of cartridge you linked above and they have worked a treat. Type this in the search box on ebay. If they don't fit you have only wasted £3.50. New Valve Tap Replacement Ceramic Disc & Silicon Washer Gasket Insert 1/2'' UK

This kit on ebay will fit your taps and is less than £4 for hot & cold.

Measure the diameter of your bath waste and the washer needs to fit inside the trap but seal against that waste fitting.

It sits inside the nut and pushes tight against the bath waste when you tighten.

You need a trap inlet washer.38mm i think.Measure inside that nut and see.

Just drill a 110mm hole and seal any gap with foam or whatever depending on the hole size. You don't need to sleeve it although a slightly bigger hole and foam will do that.

As above,but i prefer a wet finger as my tool.You could use masking tape as well as a your finger,but realy no need. 25 years ago whilst on pricework i was getting £10 to silicone a bath.......£300 an hour. Unfortunately i was only doing one every day.

That syphon will not work with that setup.You need a syphon like this

You've not mentioned the woodworm in them timbers.

You probably need a new tap but for £3 odd on ebay i would remove the rubber from the bottom of that cartridge and replace the triangular/cross shaped parts in this photo (or all parts)..They are on ebay.Check yours first and see if they look the same.

That's not to steep. You just need a minimum of 18mm per metre or in old money we always laid drainage at 40-48 inches to one.

Is it a close coupled cistern ?

It actualy gets stronger when exposed to moisture.

I am an old school engineer.Fitted my first freestanding boiler in 1976 and my first combi in 1982.I have pretty much fitted every type of boiler and system since then but would not be able to help you without seeing your set up and problems. My own system,that i have installed, consists of a...

It comes with experience.....49 years in my case.