Search results

opps double post

I did swap the two solenoids on the existing valve.. the two Orange coloured ones. you can see the top one in the pic. you can see the top one in the pic with sticker on it with the one below it.

New miele triple water inlet value is £120.. got to decide whether to fix this old machine or bite the bullet and get a new washing machine.. Which would you go with?

Thank you.. do you know which is the presoak and which is the main wash solenoid? I swapped the two orange ones (the two that are next to each other) it made no difference

I spoke too early, it only seems to work if I have presoak on but stops after the presoak section and gives the water inlet flashing error again Is the Inlet valve for the mainwash part of the triple water inlet valve?

It seems to be working again, only did a empty quick wash. Will give it a try again tonight. Thanks again Richard

is that not part of the triple water inlet valve?

Thanks guys.. it is the first time i have come across these type of hose clips

Thanks, I will try that when I get home after work, if it starts normally what does that mean? What do i need to try need? Thanks again

A quick stupid question, how do you take off/loosen these types of hose clips without breaking or damaging them please? Thanks guys.

I have a Miele WT945 washer dryer, which has stopped working.When you put a wash cycle on, the water inlet/drain light flashes red. On a drain only cycle/setting it works fine, so drains water ok. Also if I put on a spin only cycle, it works fine. It seems that it is not taking in water...

The pipes going into the radiators are 10mm approx.. the pipes from the boiler as approx 20mm. Thanks for your help :)

I can do the Dhw heat plate exchange myself as i have done that before not a difficult job. Is fitting the filter and a system flush similiar level jobs?

Thanks, what is the approx cost of getting this done?

even if it is the hot water that is affected.. the heating part seems to be working fine?

I am having the same issues again, is it likely to be needed to clean or replace DHW plate heat exchange again? I need fit a new one in dec 2011? Is this a common problem/part that needs to be cleaned or replaced every so often? Thanks for help guys.

Hi all, I am after some advise, i am in the process of laying down laminate flooring at my parent's house in the hallway. Most of it is straightforward and complete however there is a section of the floor is which is about an inch or 2 higher (raised) than the rest of the hallway. What can i...

A quick question please is a higher or lower TPI hacksaw blade better for cutting through metal, if the blades are made of the same material the only difference being the TPI? The blades usually come in 18, 24 or 32 TPI i am guessing, which is better for cutting through metal nuts and bolts...

would trying a blow torch to heat the nut be safer or more likely to damage the toilet?

thanks but one of the bolts, the whole bolt actually turns when i grip it and try to turn the butterfly nut. Would getting hold of a angle grinder make it a easier task. the toilet is in a small area so limited area to get hands in and saw backwards and forward?