Search results

Don’t worry. I’ve cut it out put back together and fine.

No Thats why im looking at doing it this wa yas that way wasnt an option

See attached screenshots. Gearbox is shot hence why i now push it & isnt an issue. Inside the wheels should be a gear which locks into the wheel so when self drive is active these gears drive the mover forward. These have been removed so there is just a shaft sticking out but vibration etc...

I would then need to strip it out, my original post was just to see if any others had taken them out before who would advise say No you cant then a reason. I will pop it out & show photo

On my mower the self drive has been disconnected & also no belt to pulley on bottom of crank. Recently I’m getting vibration when cutting grass. Looking under the mover I can see it’s the self propel gearbox. Grabbing it by hand I can rotate it as I like due to no belt being fitted & drive...

Cheers

Just found the exact date it wasn’t 13 years. August 2015 So this August it’s been 11 years.

Many thanks for the reply Have a nice day

This is something that i dont know hence why i mentioned it. Do you know then what the time frame is ? 5 years 10 years ? Just so i know. Thanks

Its already there & has been for 13 years. So you are saying from my picture in post #1 its to be measured from roof to point D thus regardless on the garden falling away

Please excuse my rough sketch but it gets the point across. I’m looking to know where a measurement is taken from with regards the height of a wooden outbuilding which didn’t require building regs & was built say 13 years ago now. The outbuilding at the rear is about two foot away from the...

This has been here since i moved in 16 years ago. I dont want surveyor to say its not up to date then cost me ££££ where i can make the change now so he doesnt flag it up. Never tripped at all so the new owner can just continue rather then let him choose at my cost

Thanks. As you can guess my goal is to not get it replaced for say £600 if i can swap out the ones that dont comply with ones that do hence not being flagged up/ I would rather spend say £100 & swap them out as opposed to him going back to buyer which think the worst & demand it be chaged at my...

Hi, I am in the process of selling my property & awaiting buyers surveyors to come & do their inspection. In my property there is the main consumer unit in the bedroom but i also have this separate consumer unit in my converted garage / office whihc is connected to my property & supplies power...

This carb was running fantastic on my strimmer. Once home I took it off & put it on my other strimmer. Cleaning isn’t the answer.

The issue let’s say is more of a fuel starvation as opposed to its tickover. Will look tomorrow thanks.

Will give it a go thanks.

I swapped the whole throttle trigger assembly from one strimmer to another of the same make / model etc. This also consisted of the wires going to coil & also throttle cable still connected to carb. The strimmer it was removed from run perfect but pull cord snapped & somebody had rounded off...

Which photo are you now looking at ? From the 3 i uploaded i dont see how its being checked with the other side. I will look & see how much of the shaft passes through the but

Obviously a mistake. Did you see post 12