Search results

Maybe they only had 1.5 mm cable …

I would go with the ply option making sure it’s attached to more than one stud …

Yes

And what was the issue ?

Take front off panel …it will go off …enter code …unplug the power supply it pulls off ..open battery compartment unplug battery ….wait 30 secs ….plug battery back in , plug psu back in , put front back on …enter code , then yes to reset ….wait to see if time corrects itself …if so it’s re...

No

They may have changed them on the later ones , they used to be 1.6 fast blow on the older ones

1.6 fast blow ..,.

Delta bells don’t ring when you first connect them … only after closing micro switch , then opening it for first time , don’t forget to move the bottom battery link

Check these fuses you need to remove them

As below

Have you tried to request an app code from the control panel ?

Ok Red to + on new sensor Black to - on new sensor Green to T White to other T And blue and yellow to the NC ( either way is ok )

Ok at an educated guess set multimeter on DC ….put probes on the red and black wired terminal ..You should if correct have 13.8v dc

Well…looking at that …there is no power connected to the pirs ….do / did they light up ? If so there got to be a junction box somewhere or the power is linked to keypad / bell ….bit of a bodge job …. You are going to need a multimeter …

Look inside control panel / post pictures That will tell us what colours to use

Defaulting the panel is normally the last resort and 9 out 10 times it won’t solve the issue

Have you tried pressing reset ? ….panel lid needs to be on

What’s coming out of the battery leads ( battery removed ) ….should be 13.8v dc ….also check aux volts …and keypad supply volts at the panel …they should all be about the same ….battery charge resistor looks ok

Have you tried 5678 first?