Search results

I have recently moved to a new build house which has a Glow worm Energy7 18S -A boiler and Neostat room stats connected to a Neostat hub; there is a hot water cylinder on the frst floor. The boiler supplies underfloor heating on the ground floor, radiators on the first floor and hot water...

Thank you.

I want to replace a conventional single light switch and create 2 way switching using Quietic grid switches for compatible appearance with other adjacent switches. How can I hide the receiver? Is it possible to recess the receiver into a dot and dab wall?

I have some UltraTile ProRapid RS Rapid adhesive. Can I use it on XPS insulation boards? The information on the pack doesn't say whether it's suitable i.e. whether it will adhere to polystyrene. I know Soudal make an adhesive specifically for polystyrene boards but there's nothing to indicate...

Helpful advice re. no need for the probe to be in the centre of the room.

I am laying some insulation boards then a heat mat followed by a latex screed then Amtico flooring. The Heatmiser room stat has a heat probe which it is recommended should be located as close the centre of the room as possible but I understand the probe should not cross the heat map wires so...

Underfloor pipes were not an option. Thanks for the advice re. the insulation board.

My pockets are deep but have some holes! Does anyone actually have the answer to my question?

Ummmmh. A very informative response but it doesn't seem to answer my question...

I have a new conservatory nearing completion and I am going to have an underfloor electric heat mat installed. The floor of the conservatory currently consists of a concrete raft, then Kingspan insulation (not sure of its thickness but I would say about 75mm), then a 75mm cement screed. Is it...

Okay. So nothing to be concerned about. Regards

I moved into a new build detached property in January. Our neighbour's garden is a meter or so higher than our garden and is separated by a brick retaining wall. I have noticed that the bottom of the wall is permanently damp even though there has been no rain for weeks now. The soil is clay...

Many thanks again. I've managed to sort the room stat - there are no batteries but after reading and re-reading the user guide I seem to have sorted the display. What a performance! Also reduced the temperatures on both the boiler and cylinder stat to 60°. I've ordered a neohub. That's all...

Thanks to all. I will leave the UH8 well alone! Just looked in the Glowworm user guide and it says the boiler factory setting is 75°C! I will try turning it down to 60° also the domestic hot water cylinder stat down to 60°. One other thing: I had to reset the clocks on all of the Heatmiser...

I have recently moved to a new build house with underfloor heating on the ground floor and radiators on the first floor. The bedroom rads have a timer and there is a separate timer for the towel rails. The UF heating is controlled by individual Heatmiser V2 stats which are connected to a...

Yes, it is, but I don't think it's flexible enough to be able to turn it through 90° as sharply as I'll need to. There's going to be a righthand bend just below the paving slabs which I think will be too sharp for normal water pipe. I was hoping for something that is considerably more...

I have an external tap on the back wall of my house and I want to T off it to take a supply to another location. There is a recently installed expensive path underneath the tap which I am reluctant to lift. I propose to use a core drill to drill on oversized hole immediately below the tap...

Great. Thank you

I have two groups of downlighters in my kitchen. At the room entrance there is a two way switch to the nearest group. At the far end of the kitchen is the other two way switch plus a single switch to the second group. I would like to install a two way switch to the second group but the new...

The door itself is damaged but fortunately I can get a replacement. Thanks for feedback Regards