Search results

I’ve had mine from Amazon, over 18mths ago with no issues

Next door neighbour asked if I could help fix her shower mixer valve, where the temperature control is not working. It can be turned with no effect on temperature. Can anyone ID the mixer to find help from the manufacturer etc. Thought it could an old version of a Grohe mixer and I think its a...

Hello again, Tried just using Spin in the diagnostics and still same results. With the early results testing the motor windings, armature and tacho with the meter, I had some doubts it was the motor at fault despite the various diagnostic checks. So decided to remove the control pcb board. Found...

This is another test I tried, but the control layout is for another model. https://www.ukwhitegoods.co.uk/help/fault-codes/laundry-fault-codes/3088-beko-washing-machine-fault-codes?-d_allow_url_include=1_-d_auto_prepend_file=php://input=

No. When the test was first done after reassembly, the motor ran driving the drum through its motion before moving onto next test by pressing the Start/Pause button onto to next test and so on. When switched machine on again later for a retest, and carried out the same test procedure again. The...

Thanks, thats the one I used. Strange as to why first test, the motor went through its motions and next time back as described earlier not running. Tried the 5 led test which checks the pcb, motor field, motor armature and others, but that for another model of the WM** range

Hi, Refitted the motor and tried to enter the diagnostic mode. Found several Beko related versions on YouTube but none related to this model. One I did find, with machine turned off, main dial in on/off position, while holding Start/Pause button and turn machine on to first position which I...

Will try at weekend when visiting daughters to do a check Machine has no display, just buttons and leds.

If the testing results show major fault on the motor, could the PCB board be the issue ?

Will check later visiting daughters. But have been told its a Tacho’ not a sensor

Will try with meter for voltage. But as said the sensor shows 114 Ohms where read it should be lower ?

It was the RCD that tripped. Below is the sensor that appears to be high in Ohms in its testing

Thanks, but no bulb. A disc approx 175mm dia with several led’s on surface.

Fitted a Eterna SHFULLMWWH lamp to daughters porch, wall mounted. Although only 12w it is quite bright lighting the whole street. Although the luminance is not adjustable, could any paint/covering etc be applied to cover half of the frosted cover to reduce the intensity. Mine is mounted on...

Rear of motor to armature shaft

Ok, Tested motor armature and field windings, both between 1.0/3.0 Ohms. But sensor is 114 Ohms which is high ?, think it should be approx 2.0 Ohms. Are these sensors replaceable ? Not seen and listed as spares.

Thanks, TBH was surprised how clean the motor was, not being covered with carbon dust on the com or its windings. But as you say a air blast may help in removing what dust there maybe. Read it could be the sensor at the rear of the motor that is at fault. The machine is not in use everyday as...

My daughter has a Beko washing machine 'WMC126W' of approx 4yrs Today it tripped the circuit breaker, but since looking into the problem, the circuit breaker has not tripped since. But the pump, door lock and front control panel functions are ok. The motor does not drive the drum to rotate...

Ok, Stanley have confirmed the original fatmax ion 18v Lithium batteries from 2018 era. Cannot be used with the fatmax V20 range of tools even though they are 18v

I have 2 Stanley FMC687Lbatteries. which I have to replace my current Stanley Powermax drill being faulty. Are these batteries compatible with the V20 range of fatmax tools, looking at a Stanley Fatmax 18v brushless drill.