Search results

Installing a shower tray onto floorboards, replaced half the width of the tray with 22ply to joist as I had some broken ones. Then was going to overboard entire bathroom in 3mm ply lay tray directly onto that? I’ll obviously make sure the ply is nailed securely to the floor but it that ok...

Geez for that price I’m better off cutting it out and replacing it!

Too big Andy, socket on boss is 61mm.

Thanks but can only find a rubber bung, where can I find a solvent adapter and cap?

Does anyone know if I can source a cap for a 110mm boss? They supply the boss with 2 sealed and 1 open end and I needed to use one of the sealed branches and need to cap the other outlet. Cant seem to find one anywhere? Thanks.

Can I boss in a 30mm basin waste to a horizontal 110mm pipe below? Not sure if dropping the 110mm into the pipe will cause excessive noise? Also would the upstream toilet flush suck the water from the basin trap? Thanks.

how would I run “through” the joists I would never be able to get the pipe in?

Thanks for input everyone. Attached some photos of plan and actual, nothing glued yet.

Going to have to raise the floor then, already 50mm into a 240mm (9inch joist)(don’t start on that one!)

Does it have to be uniform? Ie if I raise the tray I’ll have 5cm at the start or is it 18mm every metre?

I’m installing a new shower run and the tray installation states 18mm per 1m fall. I can’t get that in without rising the floor. I’ve got a 1/4 bubble fall on my level. Run is around 3-4m. I’m guessing around 4cm over the whole run. Thoughts?

Sort of works, hole centre now 260mm. I guess that makes pan height around 460mm.

Just had a thought I could swap the 90’ tee for a 45’?

Putting the 90’ pan connection supplied by grohe into the (brown) waste connector and adjusting the feet to fit would make the final pan height 500mm. I can’t see how to get it any lower with the waste the way it is?

I need to plumb this. (see photo), Waste is above ground level, floor to top of waste 240mm. To achieve a 400mm high toilet I need to plumb the 'hole' at 220mm. Looks like i'm around 100mm high. I could accept the toilet at 500mm high, although would prefer alternative option. Any ideas? I...

Yep got that, just wondering if the wall was sound enough?

was going to shower panel over the old tiles but where the bath was there was mismatch in levels so I pulled them off. What everyone’s thoughts off installing over this? a couple of holes but other wise pretty sound dabbed on solid external wall. I realise it’s not aquapanel or even green...

Hi all, I ordered an Ariston expansion vessel off Amazon and it arrived ok with invoice stating Aristotle etc but the label on the product said Varem? it this the same company/product? Screwfix sell it for £61 and this was £25 so was cheap but didn’t t include the 2 way valve shown here...

I upgraded the main last year with a new 32mm Mdpe so all good there.