Search results

Yes i am going to install a liner in and use an approved person to do it. I just prepare the place and do as must as i can.

The pipe went straight to the concrete floor, i don't have a floorboards on the ground floor. I only removed those particles in the connector and found nothing in it - as what it is shown on the pictures. I didn't turn the gas off on the main, I just clearing and cleaning the connector...

Yes i am going the raise what i have dug to the floor level. Current the depth is about 12mm. RE: Gas pipe. I tried to clear those little sand and stone on the gas pipe, just to check what's in it. I poked a pin and it went deep, as picture below. Does that look like the pipe has been cut off...

Great Thanks for the document, it's really helpful. I got a hearth of 22mm thick and might get the FireFox 5 Stove Multi Fuel. And also going to install the vermiculite board on the inner wall. I am going to cut the gas pipe and put a blank cap on it.

Yes it's for a woodburner stove. The opening width is 610mm, height 839mm and depth 355mm as the image below. Will this not fit a stove?

Hi All, I need to level the flooring for the new hearth, which I remove from the previous extended hearth that goes lower than the floor level. Any advise what cement should i used to level it before i place the hearth. And by looking at the picture the next thing i should do is to level the...

Hi, I just got a house and the fire place was covered with wooden boards. After opening it I found there is some kind of metal plate behind it, as shown in the link (https://www.dropbox.com/s/l24gwff139mmml6/20160414_172304.jpg?dl=0) I would like to set up a fire place. I need advise if...

I tried to get the pilot light on by following the instructions on the panel, but i don't see any light. Could it be the pilot light that causes it?

Hi, My 'Ideal Mexico2' boiler does not ignite at all but the C27 working good. The boiler seem to have the same kind of noise, like when it was working. However, i open up the casing and found that there is no fire. Does anyone have this experience before? Will it be a simple straight forwad...

Any advice to troubleshoot the -Hoover Classica Washing Machine Door Leaking- would be appreciated.

Yes i found the small tank.

OK will go up the attic tomorrow morning to check if there is a small tank.

Hi Jack, thanks alot for helping me with the Horstmann timer. I like to seek advice from you. My radiator valve is leaking (http://www.diynot.com/diy/threads/radiator-valve-pipe-leaking-need-advice.452364/#post-3572143) I’m thinking of draining it. My is a gravity system, I just need to turn of...

I was told that i got a gravity system. To drain it, i need to the off the (arrow show on the image)?

How do i bung the expansion tank? Do you mean drain it down?

that is what i meant by storage system.

We got a storage system. Any guide/advice for drain down?

Hi, my radiator valve/pipe is leaking (you may refer to the photo, the arrow indicated the leaking point) i am seeking for an advice before i can start to diy. I hope with this diy, it does not require me to drain the system. Is it possible not to drain the system? Btw, I have tighten it...

Great Thanks!!! It works

It is a black rectangular 'pin'