Search results

it is a separate unit

hi we moved into a house with a south facing conservatory, built into the drawf wall the is a crafft unit see below, it acts as a heater/cooler? is this what you would define as an air conditioner, anyway i have searched the web for instructions and found nothing. does anyone know the most...

hi im after any help/tips with regards painting over a navy blue ( i know) fence. we moved in to this property and last year attempted to start paining the navy blue fencing. Obviously replacing the fence is a expensive job but just wondered if anyone might have advice to repaint /what colour...

tanking the whole shower tray, i video i saw the guy taped the wall and overlapped the shower tray then used the paint on rubber membrane sorry if i didnt describe it very well this is the video its mapei installation video on screwfix

hi opinions greatly appreciated.... im about to start tanking around square shower tray, one video i saw on youtube the installer used tanking tape along the join of the shower tray and wall,overlapping the shower tray by 5mm i think it was, to be then obviously covered by the tile once...

thanks nige f

hi just a quick one, i am doing the en suite and have fitted the resin shower tray per installation instructions, the bifold door has just been delivered and im.wonder if the i fit the door before or after tiling? i was thinking by fitting the door 1st it would give me a good line to start the...

Thanks for your thoughts, so i will replace chipboard with ply and sit on the ply floor Whats your thoughts on setting the tray down?? Silcone/pinkgrip/ mortar bed? Thanks

Hi im currently ripping out ensuite and fitting a 760 square stone resin tray. Existing floor is chipboard and spongy at that,due to an old leak from the previous owner. I have already read about reboarding with 18mm plyboard but i thought i saw somewhere about sitting the tray directly on the...

Hi all firstly i would like to thank.all of you for our input. I did get panicy about your suggestions of10mm piping been inadequate for the rad but after messin around with the balacing as suggested it seems to have made a great deal of difference. The rad is now hot to the touch, although...

Upgrade pipework?? Our plumber knew the plan to replace a standard horizontal rad to the vertical rad whilst we were redoin the kitchen, all he did was move the existing 10mm pipework along the wall about 40cm

There is no mention of any baffle plate

No bought it off ebay from one of the better sellers with good feedback.

Yes thas is what i did tk check lol, sticker is the correct way up, instructions doesnt mention any flow/return directions

Thanks for the input, dont think the rad is back to front as the sticker is still on the back, i think the flow is on the left which is the side of the lockshield,trv on right which is the same as all the other rads in house(lockshield left/trv right) i hope this is right as it was a right...

I have heard of this but stickers were indicating inlet and outlet on the front of the rad, so unless they have put them upside down i wud guess it is the right way up

Hi thanks for your reply, if i remember rightly from when the ceiling was all exposed it quite possibly will be the 1st rad in the system, new boiler is in the garage, i will try your suggestion Thank you

Hi i have just installed a vertical rad 6 column 1.8m x 45cm in the kitchen. It is run with 10mm plastic microbore which all the rads in the house are. The issue is it does get warm but not as hot as the other horizontal rads. Temp does seem consistant across the whole rad when it is warm. The...