Search results

What's the white thing with the holes in for? Thanks

Can I ask what this is for that comes with the Syphon. Thanks

Can you explain is that because it won't break the Syphon till the water has got to the bottom of the plugs are in the Syphon? Does.the cistern look like a 9 or 6 litre flush to you?

Also can you get hold of the toilet handle plastic arm with the holes in like that is different to usual with the handle being on the side of the cistern. Thanks.

Does the cistern look like a 9litre flush though? The fluidmaster gives a 6 and 4 litre flush.

Thanks can I ask were the internal overflow mark is on this Syphon? Looks a perfect fit.

Any ideal if a Dudley turbo adjustable syphon would fit this toilet. Or do I really need one with exactly the same dimensions?

It's moisture resistant board I wasn't looking at tanking but would a pva mix be ok to seal the boards? Conserned water could get behind and draw the paper front off the boards?

Is it possible to scribe a kitchen work top from 10mm to nothing as the wall runs out on one side were the work top touches the side wall ?

Thanks no upstand no. So just silicone the tray to the plasterboard. Then fit the paneling directly to the tray then silicone afterwards?

If fitting a shower tray on legs. Up to plasterboarded walls. One dot and dab, the other a stud wall. Would you usually fit the tray flush to the plasterboard or cut the plasterboard where the tray sits so sits in the wall. It's going to get panelled with 10mm panels after. Thanks.

I have to swap the tap, wonder if I get a new one with short flexis I could cut the pipe above the tee and put a iso valve with a 1/2 male face on the other side. Thanks

Could I put a compression above the tee?

Will soft copper tap tails take compression fittings? Have on to swap where I'd have to alter the pipework unless I can a compression 15mm to 1/2male above it. Thanks

What's the best way of fixing to this just pilot drill and screw? Thanks.

Thanks its screwing on to fibreglass cladding so can't screw the union backplate to this before screwing the tap in as its not strong enough. As said above I could screw to a scrap piece of wood first. Thanks.

Is there a way of tightening the tap in to this without screwing the union to the wall first. There's no where on the hose union backplate to hold back on when tightening the tap. Thanks

Does it need to be above a required temperature for solvent weld glue to be effective? Thanks

What width is the listed size of a basin the back width or the wide at it largest point. Like the basin in the picture, thanks.

Do 40mm pipe snugs fit around pushfit fittings?