Search results

Thanks believe its 10mm cable and yes it has a quater turn reset dial and a test button located to the side

Thanks all.yes instructions do say one should be fitted.Any idea on cost to supply and install one,South Yorkshire area.Board is an MEM 80amp with a trip switch rating of 0.03amps

Just replaced an 8.5kw Jade II for a aquatronic 3 ultra 8.5kw so a straight off and on nothing altered anywhere.This is on a 32amp breaker does an rcd need fitting.Plainly on a new full install one has to be but,googled and can't find a correct answer on a direct swap ?.

Sooey,Yes thanks for that and it wasn't my intention not to reply thank him etc.So thanks seco even if it is well late.Its had a new TCO on outlet and retested all values on elements,coil etc,I read somewhere about poor soldered joints on the PCB but can't find it again.

Right after working for quite a while getting drops onto low pressure again,if I tap the case a few times it comes back to on .No loose connections or bad spades,also the temp seems high even when its only set at 3 on the dial.checked filter hose and head powerful flow when turned fully...

I live on the corner house the next one around the corner has allegedly purchased a strip of land from the council from the grassed area, as picture.he is now building a wall around it and this will come upto my boundry wall over my internal boundry.my internal garden boundry is around two full...

Thanks again to you all who take the time to help out.If it doesn't play on my mind too much I'll leave it.It goes back to a 5amp trip breaker with RCD consumer unit.

Thank you both for taking the time to reply,so is it acceptable to run the switched live through a fused spur located directly at the side of the other one to accommodate this ?.

Had a run on timer fan installed in the loft ducted into bathroom then out of the wall.Bathroom has two windows,looks like its taken off the bathroom light circuit,the live switched live and neutral run through a fused spur the switched live is actually chocolate blocked inside the spur,it then...

No mate,descaled both head and hose,checked inlet filter for debris nothing there,checked flow at outlet without hose connected both seem fine.

Thanks for the replys fellas,mine is just the 4 and doesn't have that part,it has a pressure relief valve fitted there.My clamp meter packed up so can't read the current pull at the moment.It does seem like the TCO is clicking in but water pressure seems ok.Full flow from hose when head removed...

Stumped on this one shower goes colder for a second or so and then gets hot again,i have checked resistence on the elements both are 12 ohms.just to be 100% certain I had a spare unit around,removed the element,and after testing the resistence both again around 12 -13 ohms,swapped it still the...

Stumped on this one shower goes colder for a second or so and then gets hot again,i have checked resistence on the elements both are 12 ohms.just to be 100% certain I had a spare unit around,removed the element,and after testing the resistence both again around 12 -13 ohms,swapped it still the...

Both approx 8-10 years old,been to CEF got a new panel and bell box.Fitted the new panel as I have had to reset the NVM a few tinmes on the Scantronic,by the time Id drilled new holes mounted and rewired the panel it was starting to go dark,so I wired in the old bell box,shows tamper light and...