Search results

Ah thanks, mine are all cheap standard ones then

OK thanks, guess no way of easily telling what has been fitted ? Special markings for a full bore?

Same as the old tap, slow, but OK for what it gets used for - brushing teeth mainly (new tap box states for use with both low & high pressure systems) ps. as a backup in case I had issues with the isolation valve I closed the gate valve feeding cold water into bottom of hot cylinder but hot...

What ball valves do you mean? Managed to fit the new tap OK so happy about that

I checked the Reviews looks like it can do both, will check the box/instructions when I pick it up. Cheers.

Going for http://www.screwfix.com/p/swirl-elevate-eco-mono-basin-mixer-bathroom-tap-with-pop-up-waste/42548 will check it comes with flexi hoses.

Got it, thanks for your help

OK thanks, that's reassured me, would hate to disconnect it then find it fails and water goes everywhere! With regards to draining, to isolate hot feed I guess I just close the gate valve feeding cold water into the bottom of the hot water cylinder ?

Hello, My monobloc basin tap has broken and needs to be replaced. I turned off the 2 isolation valves but notice one of them has the arrow pointing away from the tap, ie the wrong way around. The water has stopped flowing out of the tap but I read that sometimes a small ball bearing may fly...

Yes, I've seen those bases also. Going to go with concrete I think. Thanks for the replies.

Not sure of the spacing of timber on the shed floor as it's not arrived yet but its 28mmx44mm batons I think. Ridge height is 2545mm !! so your right don't really want to take it any higher.

OK so support the 3x2 every 600mm that would require 7 concrete blocks per bearer, seems quite a lot and a pain to level all those - if I went for 4x2 what sort of spacing would that require ?

I've ordered a new 12 width x 8 depth shed, it's floor has the joists running depth ways. I want to support it with 3x2? 3.6m length tanalised timber bearers sitting on concrete blocks running width ways. So thinking of 6 bearers at 48cm depths giving 0, 48 , 96, 144, 192, 240cm What spacing...

A Potterton EP2002 with an Glow Worm Ultracom 18hxi boiler.

I would also like more control over temperatures at different times of the day separate from my HW times, I would leave my main programmer with "CH" permanently left on and the 907 in charge.

OK thanks, will check that out

Hi, I want to replace my existing Honeywell T6360B thermostat as its not very accurate and seems to take a large temperature variation before it reacts. The CM907 seems an obvious replacement but I note quite a few reviews on other websites saying the LCD screen loses digits after a couple of...

Yes, shower doc are not sure, they've sent picture to all their suppliers. Here's hoping....

Hi, Just wonder if anyone can help, have a problem with shower temperature control not working, just stuck on one luke warm temperature regardless of control setting. Have tried cleaning with hot water & vinegar but same issue. Went to plumber's merchants but they cannot identify it. Anyone...

Hi, Could someone please advise a make/model for some heavy duty magnetic surface contacts, I have had 2 normal white plastic ones fail on me recently with a closed circuit and on closer inspection the clear reed switch plastic has typically broken. I have it mounted on my shed door but I'm...