Search results

Understood. I will then run the conduit through the wall and along the otherside of the wall and into the exisiting conduit. With ref to the 1st picture, is it acceptable to end the conduit where i plan and run the cable loose to the whirlpool bath?

anyone?

Thanks for your advice. The bath will arrive next week so i will take a look at the instructions. With ref to running the 1.5mm T&E cable within the bottom of the stud wall, is this acceptable under the regs?

Before i notify building control i want to get my plan sorted and would appreciate some guidance. I plan to run 1.5mm T&E in surface mount 20mm plastic conduit from under the bath to a cupboard within the bathroom where the CU is. I will wire directly into the junction box on the...

Has anyone got any experiences with this new tilebacker board from Marmox? It incorporates a rubber foam layer to assist with conformity with Part E building regs (impact sound). I'm about to plan a bathroom project in a 7yr old 1st floor flat, which was tiled on top of a floating acoustic...

Hi, I want to install a 16 amp RCBO in my 15 way split load consumer unit for my underfloor heating but would appreciate some assistance. I have 2 spare ways in the consumer unit which are on the RCD side of the busbar. The plan was to shift the mcb's on the RCD side over 1 way so I could...

They light up the room very well but I need side lights to reduce shadows so the misus can do her makeup :lol:

Thanks for your reply. Note taken about being zone 1. I haven't chosen the lights yet but they will operate on their own switch. I guess it would make sense to use the cables supplying the mirror light as this has a permanent live although I would still need to make a join to reach the...

Evening all, I would like some advice please on the correct method of installing zone 2 wall lights in my bathroom before i notifying building control. As can be seen in the pictures, i have marked a cross where i would like to fit 2 x zone 2 wall lights. I plan to run twin & earth...

I don't want to get into a deep discussion regarding the pitfalls of downlights as this is not a concern of mine. Safety and correct installation is my concern and my local BC has approved my initial plans. I can confirm the following - Floor above is not mine Fire rated (90 mins) The...

Just noticed the Ashley J501 is a 4 way. I need a 5 way - 2 x T&E and 3 x 3 Core & E. Typical!

Cheers for your suggestions. Unfortunately no access from above - its a tiled floor. This is all the slack i have as i have managed to get my hand in the hole and have given the cables a reasonable pull. So are you suggesting i can use small enclosed choc blocks (with cable clamps) to...