Search results

anybody???

I have currently a cooker circuit fed by 40a breaker to cooker switch. Is it possible to wire my hob onto the outgoing of switch and run a 4mm cable off incoming side (daisy chained) over to other side of kitchen to feed another cooker switch that supplys double oven manufacturers spec...

yes it is accessible it is an internal wall why would this be of significance thanks suppose power tools are out the question box sinkers etc

whats the best way of fitting a recessed socket into a single bricked wall without ruining other side of the wall when chasing out thanks

cheers swidders thanks so gripfill is a no no

yes i just want to lie it flat on normal floorboards i want to fit waterproof laminate boards for the rest of the floor in bathroom what should i use on base ? some sort of mastic? i can run the laminate boards under the shower if need be will it be better to lay shower on the laminate...

it lies flat to the floor

Just about to fit a stone resin shower tray onto wooden t &g floorboards Can i place this tray direct onto floorboards held with mastic, or should i make a wooden frame & base for it to sit on? i hear tilng should be done afterwards for a more waterproof fixture any help appreciated before...

Is this possible i Have an unvented cylinder but central heating i think am right in saying is vented because i have a tank in loft i want to pull a plastic pipe (push fit ) off existing rad to change trv if i switch off the rad and drain will i be able to pull plastic feed pipe off and...

Never used plastic piping before SO on every joint must you use inserts On every compression and every push fit connecter??? im about to add another rad existing pipework is plastic 10mm thanks

thanks rebuke

are you sure im at the design stage but thought it could have been possible thanks

if two independent switches were feeding two independent lights respectively Could a master switch (2 way switch) switch off both of these lights? how could this work? thanks

yes i mean sy cable (steel wire braid cable) thanks pic:- http://www.diynot.com/network/darren bergin/albums/

can you use flexible armoured cable to feed outside lighting buried underground and ran surfsace mounting without any additional protection..? i know normal swa cable you can use just wondering if same applied to flexible armoured thanks

what would cause the flame to go out when hob set down on low heat setting thanks

cannot the outer be sealed at base of flue liner?? would make the job a lot easier thanks

hi if removing old back boiler unit from class1 fireplace and fitting inset living flame gas fire.. Flue liner looks good .. but should the liner be removed fully?? or can it still be left in situ?? thanks