Search results

is it sludged up or is it the black inhibitor thats coming out?

you need to take it out and flip it over,remove the base giving you access to the hotplates disconnect and replace the hotplate.its straightforward.

If your water pressure is good elsewhere it should be ok for the shower if its mains fed,have you checked the obvious like the filter into the shower?

Bath /appliance chip repair paint ,most diy places sell it

most B&Q have a wood cutting service 4 free cuts then 50p a cut after that .Cheaper than postage

the red wire looks as though its' not connected you can see the copper wire showing that should be inside the connector block

Is it tight seems to have a lot of copper showing?

What else you got wired off your shower{the thin red cable coming out the live side]

You can do it no problem, the hose connections will be still in place from the old machine.Try disconnecting your old machine before the new one comes and you'll see how straightforward it is

Sounds like a perished washer,have you checked the washers?

how high is it if it contains a sink?

Why cant you sand it?

You need to speak to building control plus your achitect ,he's the one thats paid a lot of money to research these matters

did the pressure rise on your boiler when you had brown water?

100 x 100 set in concrete every time

Try 8mm pvc tile beading,not too thick and wipes clean

Dont know if there is a minimum distance,its the amount of water that creates the pressure

Could be it was used as a bedroom before but with no planning permission and was taken down before it was sold. How large is the floor area going to be?

Quite tricky and time consuming ,there not usually incuded in free fitting offers because of time.But times are hard for all retailers and asking for free fitting could be the difference between them getting your money and someone else. If you dont ask you dont get

I'm saree but your going off topic :D