Search results

Might want to default your panel and start again I'd recommend, you just compromised your alarm, and also Joan's if she uses the same code for her home or work or whatever. Your master code ends in a 5 Your engineer code ends in 00 Joan's code ends in 321 And it's not a good ides to...

Message center numbers are still running? Vodafone - 07785499993 O2 - 07860980480 Both got shutdown didnt they.

You dont staple to plaster or mortar. End of. Fair does to you if you have a giant house made of wood though.

Gateway IP definately correct? Would still work over wifi if it wasnt. You seem to say your only opening the ports one at a time, why not open everything it might need, also if it asks for port 80 its almost always a web interface so have you tried browsing to your internet address to see if...

If you can access correctly over wifi or LAn but not internet then clearly it isn't setup right somewhere. Can you give model numbers or some of your equipment, you dont mention if its IP cameras with an NVR, or standard coaxial camera with a DVR. Anyway, stuff i'd check is follows. -...

I just unclick mine from the base and click them back in again. No messing if its easy to reach.

Did you fix? Be interested (cos im geeky like that) to find out what the problem was.

Panel 20 year old too? Could be panel struggling to supply power to everything, or panel with resettable fuses, either of these could gradually overheat and drop voltage to the sensors.

What do you mean by fade? Get dimmer or go off completely.

Stop using suites ! Or if you have stopped using suites, stop saying the word suite. :P

Does this mean you totally defaulted the system as I said? Or you 'reset' the system, like using the reset button. As for zones showing up I've never known them not show up even if disabled. The only thing im struggling to think of is why you would only get a single error tone and not...

Its not arming then I would say. Your getting an error beep but I dont know for what reason. Wouldnt say you should be using suite's, just stick to having zones in areas and stay away from arm suite's. Personally i would default your panel completely and start again, once you connect...

Same ^^ Replaced a lot of them about the same age as yours for the exact same.

The question was answered it seems, if indeed you set it back to defaults and the logo still remains then that logo is clearly 'a default'. As to why the logo is a default the answer would be, advertising.

Rebadged panel made by Bardic, its a Zircon. http://www.bardic.co.uk/downloads/tech/61640620.pdf :D

If it ten years old get rid and get something new installed.

Possibly, but as the Paxton is looking for a normally open switch closing you'd have to wire them in parallel, and assuming the output of the videx system is an open switch closing when the door release button is pressed in the handset. If the output from the videx system is a voltage then...

Only reason I mentioned the door/vibration thing is because you said... Go for Vib if you want :D

Flush mount backbox for your keypad? Part No. DBE-0002 Substitute GBC-0001 which are actually wireless door contacts (and a few quid cheaper) for your GBB-0001 which are a vibration/door sensor. Roll of 8 or 6 core alarm cable for wiring keypad, siren and internal speaker.

Do you hold it against the prox long enough? Its about 5 secs before the setting procedure starts.