Search results

try replacing just the plugs first. Fuel injectors are pricey £250 - 300 will be for the one injector.

crank shaft position sensor would be my guess. Post it on mg-rover.org forum. They have everything you want to know about them over there.

Broken spring, worn bushes, or knackered damper could all cause this. How many miles has it done?

I am digging out for the footing for my new brick porch. I was planning to dig 600mm down and 450mm wide, but 400mm down I have hit solid limestone. It is not that hard -as far as rock goes, but it is going to be a lot of work to break it up with the SDS drill and dig out another 200mm...

People seem to pay more for the old colour stuff on e-bay than they do for the new colours. Sell it on e-bay would be the easiest/ most profitable way to get rid of it.

No, in a short answer. They work in a totally different way to normal fillament type light bulbs and will not work with dimmers.

I am renovating the brick porch on the front of my house. It has a 2 brick thick wall with no cavity. I would like to damp proof it and paint the inside. At a later date, I also want to move my boiler into the porch. The wall moarter is very sandy and crumbles easily. I can brush sand off...

Had I known about this a few weeks ago, I would have put in metal conduit. However it has all been tiled over now. I think I will have to find another route up and replace the wiring. Was it in the regulations in 1965 that wiring had to be in the zones, or could it go anywhere on older...

In my bathroom wall, there are two vertical cables (1.5mm twin + earth) for the upstairs lighting ( 3 floor house, bathroom on second floor) They are just in the middle of the wall and I did not know they were there till the bathroom tiler drilled through one. These are not in any of the...

do you have a definition of "adequate clearance"?

Thanks for the quick replys. This is an excelent forum. I wish I had descovered it sooner. You are right, I am not a Corgi engineer and I am just installing the water pipes, but I still need to know where the boiler will be located on the wall. I plan to leave a hole in the ceiling, the size...

Hi, This is my first post and I hope someone can help me. I am installing a Vaillant 831 condensing combi boiler and want to know if it is legal to have the boiler mounted high on a wall, on the ground floor, with the right angle flue going out through the wall effectively in the floor space...