Search results

Thanks, very helpful. .

Parker's do a week's/months etc subscription online.

I have to get the walls up to dpc for the carpenters to do a timber frame extension. The bricks are class b engineerings with 3 large holes. I assume you have to drill in to them for timber frame so in wondering if these will be suitable? Cheers

Yeah. Or say I have painted them but you can't get paint that lasts these days.

Hello. The drawings show about 8 courses of bricks with a plinth course along the front of the house with the words "to be painted grey" it seems now it might look better to use red bricks and not paint them. Also the hatchings indicate the porch will be rendered and white. Any chance for it to...

Thank you young man. I managed to find both the relevant bits I think. At least it's an option.

Just wondered if there's anything against render below the dpc in the regs? Avoiding bridging of course with stop end above and below the dpc. This is on a new extension on the side. Thanks.

Thanks everyone. Had a look today and seems it's copper probable all the way. I couldn't get an olive over it though. seemed to be a little too thick. Don't think there was an imperial one about 17mm? Had to buy a philmac coupler for a fortune. Also I think I've knackered the stop cock on the...

I hired a concrete breaker and the pointed chisel broke after an hour . Just sheared off a few inches down. Then the spare one did the same. The flat chisel has lasted a week fortunately. Just wondering if anyone thinks I should put up an argument if they make a charge. As it's happened twice...

Ta. I didn't know that had to inspect it.

Thanks. Do you know if that includes the digging?

While digging in the front garden I came across the incoming water pipe. It's 15mm copper near the house. Presumably connecting to lead? I think I will get a new one and contact the waterboard. I believe you do the digging for them So can anyone tell me what depth they should be and can I use...

Hard to tell where exactly. Couldn't hear it when I was stood in front. Oil level was ok. Oil was changed a year ago this week though. 15 Old vw Passat diesel. Just normal slow driving was enough at first. Then it seemed to have stopped but I didn't dare to drive it for long.

Thanks. I actually should have written Jack hammer not whacker plate but take it I could run them both on the same oil. Cheers

Thanks. I wonder if it's a misprint.

Hello. I need to buy 20w/50 monograde oil. Only need a small bottle but when googling it I haven't seen anything described as monograde. Seen something close like the one in the picture but don't know enough about oil. It's for a whacker plate (compactor). But I thought you on here would know...

I used the cemex Ready mix calculator. They said 3.2m cubed. If you mix it yourself You'll use all in ballast usually. If I remember rightly there's a minimum of.850 in a bulk bag. Allow 6 bags of cement per bulk bag for 6 to 1 mix. Also if I remember rightly.

Thanks people. I'll try a small patch and see thanks. Yes it's an old house, dado and picture rails etc. Cheers. But I thank blub for his help. If anyone can recommend a brush for cutting in id appreciate it.

Hello, I would like to paint over some dated paper. It's a thick embossed one. There are a few damaged patches like the one I've attatched. Does any one know what kind of filler might be best? I've tried painting the paper on a bit that can't be seen and 2 coats seem to be ok. Cheers.

Yes vw. Cheers The check brake pads is up on the dashboard. If there's a hose for ABS and brake pads shouldn't there be another lead? I'm assuming the one with damage is the fluid and the other is the pads sensor? Cheers