Search results

anyone?

or if you have lots to cut http://cgi.ebay.co.uk/Quality-Ceramic-Tile-Glass-Drill-Bits-18-99New_W0QQitemZ120098661127QQcategoryZ67240QQrdZ1QQcmdZViewItem#ebayphotohosting

how did you fix it? I would like to know! are you sure it was wired correctly from the shop? Darren

these are nice http://365drills.com/ darren

ok .... can explain the square or round differences. I have been advised for a stone floor, 10mm but is this a square or a "U" round, the tiles are 10mm thick and heavy. and also for the wall...what size for the wall, some have said 10mm u notch as well? they are a 303x305 10mm granite, so...

sorry forgot to ask....... as you were honest about the help...what will you be cutting them with ( make and model) this will help people advise you better. Darren

ok go to the bal site for full specs....or the wizard jasonb or one of the other pro will answer....... Im deffo not a tiler! I think its around 20- kg per square on plaster board..... and if its a wet room go for Aqua panel.......(put them on the scales! make suse you have not we sold(...

ok thanks...... just thought the small 80-100mm ones would be good, i know people like the Marcrist, blades. they are twice as thin as the cr*p ones. cutting a dead strait line with and angle grider? do you use a guide, template or something? Thanks

hello, could you tell me the method for cutting a small square in the middle of a granite tile. for something small like the size of a single socket, in the middle of a 305x305. I understand that some use an angle grinder with a diamond disk, but a 115mm will be to big I think, and not...

Pro advise please.... I took a look at my cast soil stack and measured the internal diamater, as i have a new back to the wall toilet. the pipe on the main stack was the nomal cast size 102 internal dia. what I was going to do was cut the bell of the old piece and fit a flexi or an adapter...

yes this last one went for £500 second hand! I so people just replace there old one like for like, on the quiet Daren

Hello my friend is looking to replace his back boiler, and has been looking around. He saw one go on Ebay, and with the inset front it went for over £500! It was very good condition... I looked the price up and new it would have cost around £1700 complete. what I am asking is we have...

ive always seen a decent gap round the edge, is it floating of glued down? Is the sub floor nice and solid to reduce the SPRING? Darren

tile up and not down? Darren

mmmm it looks like a job for aquapanel. Darren

I have pushed the pan in the correct position, so it defo is a fair bit out, would what I said above be correct? Darren

thank you Jason. Darren

I cant seem to find any places that stock the Schlüter QUADEC tile edges, I want the 10mm stainless round a window edge, as I like the square look. anyone Darren

Ok thanks Guys, well the new W/C is back to the wall so it will not be in exactly the same place. its around 300-400mm out, Yes i like the Multiquick quality, but what would you normally do, cut thing around 700mm down the cast and covert it to plastic MKEP110, so you can get it in...

Hello I have a back to the wall toilet that I will be fitting, the waste comes out horizontal so I will need some sort of 90 degree pipe, as my waste is under the floorboards. the waste is a cast iron type and has the bell on the end, that goes up vertical. I was going to cut the bell...