Search results

Thanks for all the feedback. If I decide to site the sockets under the worktop, would it comply with regulations?

I want to take plug off kettle, reattach plug under worktop and then plug in socket.

Thanks for suggestion , but would having sockets under the worktop comply with regulations?

i would like to tidy up the clutter of cables on a small kitchen worktop. Am I able to have the sockets for the kettle and toaster under the worktop and the cables drilled through the worktop and then plugged into the sockets under the worktop? Thanks in advance

Hi, it is an old combi boiler, Sse changed the heat exchanger approx a year ago. Now there is only a trickle coming out of the all the hot water taps, heating all ok. Any advice appreciated . Thanks

Thanks, l,ll order one

hi, I have a BPT c200 handset coming off an entry system in a flat with 4 x terminals numbered 1-4. I have purchased a commax ss phone to replace it with 6 x terminals. Can anyone please confirm which wires go from the old BPT to the new Commax please? Thanks

i would appreciate a Bit of advice please as there is conflicting views on the site. I have laid 18mm wbp ply on a bathroom floor after ripping up the old chipboard floor. - should I use 6mm hardie boards on the floor and are they stuck to the ply floor with tile adhesive and screwed? Also do...

Hi, I am extending my bathroom to fit a 800 mm shower tray (taking some space from landing). I was planning to build a frame to surround the tray with 4 x 2 and then use 12mm hardie backer to line the walls of the shower area. The tray is a resin tray which I plan to sit on the floor. Would...

Thanks for all your replies, much appreciated

Thanks Hugh, much appreciated

Hi, I am fitting a bathroom and the soil pipe that the toilet goes into continues up the wall into the loft and through the roof to vent. I would like to re configure the bathroom and it would be helpful if I could remove the 4 inch pipe going up the wall to free up space Could I replace with...

Hi, I have looked through other threads, but looking for a bit of advice please if I post. I am fitting a new bathroom, two of the walls have plaster board with a cardboard sandwich in between, where there are bedrooms on the other side of each of these walls. Another wall (brick) has...

Thanks for replies, the dual outlet plate looks like a good option. From one of the outlets is it recommended that it feeds a socket, so that the oven can be plugged in with a 13A fuse?

Hi, I have just bought a flat with an electric oven under a worktop and an electric 4 plate hob sitting into the worktop. I want to replace the hob. I have taken the oven out and it appears the oven (electric) and the hob have both been wired into the outlet plate on the wall (turned on...

Hi, I have just laid a base of type 1 mot, in preparation for a gravel driveway, 55 tons at 6 inch depth. I have a number of area where there are just the stones from the mix and no grit to bind them. Can anyone suggest please what I can use to bind the stones and then re-wacker plate them...

Hi, I hope you can help please with some advice. I rent out a 3 bedroom house out with a Ravenheat combi boiler (approx 10 years old). The heat exchanger has clogged up for a second time in 2 years and water fluctuated between hot and cold water. It has a fernox magnet filter and an in line...

Thanks Tony, much appreciated

Hi, I live in an end terraced house, next door the neighbour who is at the end of another terrace has applied for permitted development to extend his house. 6 years ago he extended his house on the ground floor approx 4m and now wants to extend a further 2m. This will result in the extension...

I realise the thermostat may not be expensive, but the waste pipework is behind the cylinder and the cylinder would need to be drained down to access it, would the manufacturer carry out the repair?