Search results

The problem is fixed, for now. The issue appears to have been caused by a faulty Flow Meter Circuit Board (FMCB) that is accessed by removing the left hand side panel of the dishwasher. The FMCB is about 1.5" long by 0.5" inches tall and is connected by two orange wires. Tapping the FMCB hard...

Good and bad news. Lying the machine on its side, and by removing (only) the bottom from underneath I've replaced the the Inlet (Aquastop) hose and removed and cleaned the drain hose. I've also replaced the non-return valve. Alas, this hasn't fixed the problem. So I am still getting the Inlet /...

https://www.flickr.com/photos/27466575@N03/51067975588/in/dateposted-public/ I am replacing the Inlet Hose with its built-in valve (Aquastop). So far I've removed the rear, side and (outer only) rear panels. But the Inlet hose connects inside the machine. I think I need to get behind the...

I thought I'd found a cause, or at least a symptom, with my G1143sc dishwasher which usually stops soon after the cycle starts. The attached video shows the problem, water starts to fill, then it stops and a banging noise is heard: I've kept the video short so it shows the fault happening only...

If the specs on the Amazon link below are correct, the freezer is 81/281 (28.8%) and the fridge is 200/281 (71.2%) of the gross capacity. And the freezer is 65/263 (24.7%) and the fridge is 198/263 (75.3%) of the net capacity. In my Bosch FF, the rating and capacity label inside the fridge...

I've just asked a similar question and hope to get some ideas.

Update - here is a video of what happens 13 seconds after switch on. In fact the wash cycle (more than an hour) does not seem to finish. Or when it does the Infil/Drain light stays flashing. I don't know if "Infil" or "Drain" is the problem.

Is this a possibility -> https://spares2repair.co.uk/bitron-inlet-tube-aquastop-safety-valve-220-240v-alternative-for-miele-7638500 But I would check with the company as I think there are several quite similar hoses but which fit different Miele models. Good luck.

Miele Dishwasher G1143 SC - inlet(?) banging + Inlet / Drain lamp warning When initially filling and again about an hour later (I'm guessing when the rinse cycle starts) , the dishwasher makes a banging noise. The flowing sound of water stops suddenly like a "glottal stop" making a kind of...

Thank you. Is it adjuster 1 (in yellow) or adjuster 2 (in pink) below that should get rid of the gap, please.

The handle of my UPVC patio door wouldn't lift up far enough to allow me to lock the door with the key. So, I played around with the Vertical, Lateral and Compression bolts that are part of the Trojan Patriot 3D Flag hinges. The vertical adjustment fixed it, so the door now closes and locks very...

This is currently being sold at £56 by Wickes and around £96 by Screwfix. Are there maybe different versions of the st9400c or have I missed something.

Commercial and trade operators usually use 110v power tools. Some comments say the reason is that the lower voltage reduces the impact of an electric shock. On it's own, that makes sense. However, I thought that: (1) it's more the current (amps) that kill (2) Using a transformer to reduce 220v...

I've got the Receiver installed by qualified heating engineer. I didn't think the Bosch instructions were clear. After wiring, the Receiver wouldn't communicate with the Hive Thermostat. The next day I rang British Gas support and they said ".. oh yes we have yet to activate your system..."...

Ollie20, thanks also. And I note your comments.

Thank you

I want to install a Hive receiver with a Worcester Greenstar CDI combi boiler. At present there is no Programmer installed and no room stat connected. So the boiler is either on or off with the temperature in each room only controlled by TRVs (where fitted). This is a new build really, and this...

I'm adjusting my UPVC door. The (flag) hinge adjustments were logical and worked easily. But at the side of the door, there are some knobs (highlighted on the attached) that rise up as part of the multi-point locking mechanism when the door handle is operated. Presumably that's to hold the door...