Search results

i'm about to totally re-do a bathroomand the flooring going down will be laminate. Is it ok to lay the floor complete then place the toilet and sink on it rather that cutting the laminate to fit round them?

and how long would it take to plaster a 25sq/m ceiling?

whats the going rate for a plasterer, i'm in scotland if that helps, just a ballpark figure

I've just removed blown vinyl from my lving room ceiling and can see why was there in the first place, it is quite rough and looks like a very thin layer of plaster was put on over the orignal plaster, this is now flaking off with the paper removal. What are my options: the room is approx 25m2...

hi, i have recently moved into a new house. All the rooms have a single light pendant in them, if i change some of these to 3 light spots or downlights would i overload the circuit?

but are they safer to install/use?

Has LV lighting got any advantages over MV downlights?

An upside down blade at fault? are you serious?

no its revving fine, its just like the angle of the bag ist oo steep, so the cuttings are blown in, the slide down to block the entry chute

its the honda engine thats on it

hi, i've got a mountfield mower, but there seems to be a design fault or am i being a fool. It seems that the rear collection bag is at too steep an angle, therefore instead of the grass being blown into it you get some through that then blocks the exit from the mower as it slides back down...

was going to do it as infill, just have 15mm of the plinth at top of the units

yeah, i hung a doot, but with it being gloss black, and the carcass is white, the 7mm top and bottom looked well wrong, will go for the infill, reckon if i by another plinth that would give me the wood needed for the infill

many many thanks guys, might have saved me a lot of work and money!

what do you mean by doing infill? What about the wall units also?

was going to take the top off with the cams, cut the sides 15mm, then re-dowel and cam, would this work?

they are cam and dowel units. Cant take the doors back, anyway they are standard size, its the untis that are different from the norm. The doors are high gloss black

thought would smarten up my kitchen with new doors, however, the doors are 15mm smaller than the units. Is it possible to cut 15mm off the top of the units and fit the new doors as normal?