Search results

No it's just a crack. Light fitting wire bends away from it

Hi I have removed a few some 'lovely' textured ceiling paper. However, I am left with several cracks in the ceiling plaster. The ceiling has very little movement so planning to just get on with decorating it. My question is should I just fill the cracks and paint over them or wallpaper then...

Thanks this worked

Hi hoping someone a lot more knowledgeable than me can assist. One of our security lights is out. I suspect it is the light not the sensor as the light is a lot older. I would like to attach a smaller light to the circuit rather than replacing the original light (it is about 5 metres up and...

Thanks for everyone's input this was a wiring issue which Sunray's image solved

Yes turn cord off and turn it back on a fuse box and light works. Pull cord and it trips again

Hi all Fitted a new light in our closet. Existing wiring just a different light fitting. Worked fine before. Now when I turn it off it trips the system. Thought it was the fuse near the light but turns out there was never a fuse in there anyway. Wires appear to be where they were originally so...

I fitted a new euro cylinder but it is faulty. I can't remove it because it won't turn enough to release. It turns a few millimeters but won't move the deadbolt starting to panic as it's getting late and gate lock the door. Key is also stuck in lock as it won't turn enough to release it. Any...

Hi We own a 1850s (may be earlier) stone house and have begun exploring whether we can expose the fireplace in the living room. We have located the height at which the original (very large) stones are. Below that is loose (by just touch) smaller stone. However, on the sides of the current...

Unbelievably, it was just the reseting of the nest controller that got it working. There's a day I will never get back. Thanks for the suggestions

Set up attached. I have reset my nest panel and hot water is now leaving the boiler but not making it to the diverter valve pipes.

Hi A bit puzzled at the moment. I removed a section of central heating pipe that had a screw put through it. Since then we have had no hot water or central heating. To solve the issue so far I have done the following: - Bled all the radiators (alot of air released from those near the fixed pipe...

Hi I have a pressure gauge on the outside pipe just before it enters our house. It has started leak. Is it just a case of turning the water off then swapping it for a new one. Do I even need a pressure gauge or could I just close it off? Thanks in advance Kev

Thanks I can't locate the other of end of the wire so will have a think about the easiest alternatives. Appreciated

I have a couple of these outlets by windows in the kitchen and bathroom. One is currently attached to a working extractor fan in the bathroom so I assume the one pictured did the same in the kitchen (wires are still live). My question is...can you buy blanking plates this size and also working...

No leaks so looks like it did the trick

Went with ptfe tape and feels pretty tight. Water goes on tomorrow so will find out then

None, just some lsx

Second attempt at picture

Hi Experts I am replacing a leaking drain of valve. However when I screw it in to the radiator it does not tighten in suitable position. I.e. drainage point facing up and the screw to open valve against the wall so you cannot reach it. If I leave it in suitable position it is not tight. Any...