Search results

Have a sealed system.... with the flow and return at the hwc, the return has a non return and gate valve headin up to the tank.... do i leave this valve open or closed

pump seems to be on but i say its the pump... is there anyway to see for defo if its the pump

Upstairs rads were very hot and downstairs not as hot.... so turned off all rad upstairs to see if downstairs get as hot as upstairs but they didnt get hot at all..... whats the problem here...

My rads range from 40-55 degrees in temperature... is that ok or should they be hotter... my boiler is a potterton prima c bout 10 year old

lovely cheers bud

No mate... tryin to see if anyone had the sheet... think it was a iphe sheet i got

Does anyone have instructions for copper bending with a benders... i had a sheet but lost it....

Have a potterton boiler... gas... 8 rads... the temperature off these rads range from 36degrees - 45 degrees after bleedin them.... is this a low heat output.. have thermostat up full wack.... is there another way to get rads hoter...

For tank in loft... does the ballvalve need to be a part 2??

B&Q toilets.. they all seem to be close coupled but i need a low level one.. can i add a flush pipe to some of them

someone said get .2bar taps instead but itd save me hassel if i put the 1 bar ones in... would they work... theres no pump for the hot

Got a set of kitchen taps... it says minimum operating pressure 1bar... the mains should be ok... but the hot im not sure.. the hot water cylinder is upstairs

pump on heatin system keeps turning off... i have to knock it off and turn it back on to get it back started... Is it coming to the end?? or just need to be bled

does the copper wire go down by the screw and out the only hole and then screw down the screw on top

Cheers... all it has is 2 connections for the two cables, does it matter what side the cables go in????

The lights are old,a bit of wear and tear.. i just want to do a straight swap with new ones... is all i have to do is turn of electricity and swap