Search results

Nice one, many thanks for the info:)

Erm not sure what you mean sorry:-/ On my previous setup an mqtt packet was sent over WiFi to activate a relay on a sonoff sv. when the relay is energised it made the connection to the garage door (same as if the open/close physical button is pushed) opening/closing the door. I think I just...

Premier elite 24 pcb

12v relay

Right I have the relay and am happy with all the wiring etc. Using wintex I've set Panel Output 1 to Pc Control 1. Is that it or do I need to have a certain attribute checked?

Many thanks for the reply So that relay should be compatible then? I'm happy with the door wiring, just connecting up the alarm panel control not as sure. I'll grab the relay and hopefully things will be a little clearer with it in front of me

Hi:) i have been using a sonoff sv and mqtt to open my garage door with my phone up to now but am concerned about the security of it all. so want to utilise my premier elite 24 and smartkeys. would this relay be compatible...

hi:) apologies if this is in the wrong section a search threw up loads of different sub forums for bathroom extraction. i'm renovating an 80's dormer, the bathroom which is upstairs under a dormer epdm flat roof is completely stripped out. for info i'm also installing rigid pir insulation...

Hi:) Renovating an 80's house and looking for options on improving some poor brickwork and awful repointing done on the front of the house. The house is built on a slope with the garage/lowest floor (the problem area) sticking out from the front of the house, this provides a balcony where the...

Hi:) I'm renovating an 80's house with large dormers on the front and rear. Ive had the whole roof replaced including the dormers (epdm). The roofing company didn't initially install any ventilation on the flat roof soffit. As I'm also retrofitting pir insulation in a cold roof design between...

hi:) i'm creating a storeroom/emergency bedroom under the stairs, and wish top add a door. i've measured up and after installing the carcassing timber i'm going to be left with a max gap of 720mm, which i believe will mean i'll have to install a 610mm door? looking at door linings most seem...

door lining

Hi, Does it need to be left in an area its being installed to acclimate? Can't find any reference online apart wood flooring, so I'm thinking no. Probably a stupid question but thought I'd ask anyway:-/

Thanks guys, Already purchased the bm17 plates, there's only a few quid difference between the larger and smaller ones so I went for the biggest. I'd rather know its all solid as eventually I want to replace the composite deck top with slabs on adjustable plastic posts like these...

Thanks for the advice guys I can't lift anything from above due to the epdm roof. I have a mini circular plunge saw which cuts to 25mm in depth, I was going to use that to start the cut, then finish with my reciprocating saw. What's the concern with using a circular saw.? some kind of...

going to replace all the ends with the BM17 bower beams, they are 1000mm and up to 17 inches can be removed, for the worst one i may replace the end then sister another joist next to it. tooling wise whats going to be best to achieve a square cut on the in situ joist?

Hi John, Thanks for the reply Everything is dry, it's been watertight for over a year and we had 3 dehumidifiers running for a month down there. I've just been down there again and tested with a sharp blade, although as pictured they dont look great they're mostly solid. I've seen these BM17...