Search results

  1. P

    Samsung washing machine wearing away door seal

    Samsung WW90J5456MWEU The door seal was getting torn up and bits of the seal appearing both in the seal lip and in the filter. So I changed the seal last week and it seemed fine until today having been used about 6 or 7 times since. I was in the house while the machine was on and while it was...
  2. P

    Samsung washing machine lid removal WW90J5456MWEU

    I need to replace the seal on this Samsung washing machine and so I need to remove the top lid to get at the retainer. All the videos online show two screws at the rear and then push the lid back to remove. So I've taken out the 2 screws at the rear but it seems like the top is still being held...
  3. P

    Door handle operates day latch but not full locking system

    We have a composite door with a 3 point locking system and a wind latch to stop the door opening even when it's not locked. This morning the door wouldn't open and my wife said it felt odd when she locked it last night. It didn't seem to be properly locked with the 3 point system and after a lot...
  4. P

    Miele corded vacuum motor speed varies

    I've got a Miele cylinder vacuum that when turned on the motor spins up to almost full speed, then slows down, then speeds up again and just goes up and down. Obviously not much suction as the motor keeps slowing. I've removed the hose, bag and all the filters and it makes no difference. Anyone...
  5. P

    Radiators only luke warm and bolier not running for long enough

    The boiler is a Baxi Combi 133 HE Plus which is quite old now. The problem is that when the thermostat calls for heat, the pump comes on and the boiler fires up as expected. The flow pipe gets really hot but after about 2 minutes the boiler stops firing and the pump continues to run. After a a...
  6. P

    Baxi combi boiler DHW fine but won't fire when heating needed

    Boiler is a Baxi combi 133HE+ and has been having a few problems. The current problem is that when the thermostat calls for heat, the valve on that circuit opens and after a few minutes the main CH pump starts to run. The pump runs for almost exactly a minute without the boiler firing up and...
  7. P

    Composite door in timber frame porch

    Our house has a small tiled porch roof with gallows brackets outside the front door. I decided to box this in with a timber frame and cladding. The idea was to put a door in the middle with windows to either side. The whole thing is only just under 2m wide and about 75cm deep. I started off...
  8. P

    Baxi HE133+ makes very loud banging noise and then red LED comes on

    I went to do the washing up and turned the hot tap on and heard a loud ban from the boiler! I turned the tap off straight away but the boiler kept on making the banging noises so I turned it off at the mains. Waited 5 mins and turned it back on, turned the tap on and it starts banging again and...
  9. P

    Boiler overheats when only UFH is on

    We have a "Baxi Combi 133 HE Plus" and over 5 years ago had a new kitchen built with underfloor heating. The output from the boiler is T'd with a solenoid valve on each branch of the T. One is the radiator circuit and the other goes to the UFH manifold plus a small radiator. Solenoids controlled...
  10. P

    Another Bosch dishwasher 1 minute heater problem

    Problem with Bosch SGS46E02GB/75 - the common issue of not moving through the cycle and still washing when display shows 1 minute. Also whenever we stop the cycle the time goes up significantly. Anyway, having had an engineer tell me it's the control module I have confirmed that it isn't...
  11. P

    Bosch dishwasher not filling & its not the inlet valve!

    Bosch SRS46A02GB/08 about 4 years old and no water is getting in despite checking hoses, supply and replacing the inlet valve. The module has also been tested and is fine. The drain pump works if I fill the machine manually and then abort a wash cycle. The drain pump is also triggered by...
Back
Top