Search results

The boiler starts burner comes on for few seconds and then goes off and few seconds does the same and so on, there is a clicking noise :?

the one facing you when you look at the valve

OK thanks I check that

the pump runs only on H and its off on DHW and that as you know the classical system, its not a fully pumped system :roll:

the feed tank is full, the cold feed !!why doesn't do that when the heating is on?

what are you talking about, its done by changing that and its only less than £10, by the way do you know what are we talking about? I think you haven't got and idea, and in the future keep your language to your self

it is and old cavity system, no zone valves just a boiler, pump and controller for DHW & H/DHW, the problem on DHW only after few minuets start to make a knocking nose and a boiling water comes out of the vent pipe, any idea?

it was the main thermistor, as this tells the boiler that it is frosted and that keep the boiler on, the reed switch is one of the causes, but as I said it was ok as you can tested out of the boiler.

don't know what to say, some one thinks the main thermistor, I might try that and see :?

because when it is out from the boiler it is open circuit and the water flow in the heating circuit close it.

can you explain what you mean

the reed switch is ok

This Genus 23 MFFI stays on as far as the power on even when the stats is right down, it goes off when the reed switch diconnected, what could it be the problem?

Hi, any ideas.... the Baxi Solo 3 does not heat the water and heating output is not very hot at all, I notice the flame is only few mm, I mean very low, why is that?