Search results

Thanks Derry. The surewire looks pretty good. I don't really want to be extending any circuits on the right of the JB as they look quite neat but the left hand side has just been laid on top of the joists so I need to route those through so I can board the attic out. If I do extend the wire...

Good morning all, Is there anything on the market that I can buy to replace this in my attic? It's used for the upstairs lighting circuit. I was going to tidy the left hand side of it up and when I tried to undo one of the terminals it sheared. That's the second time now. Last time I used...

Not really if that is normal. But it could be something beginning to break down and may get worse.

http://www.screwfix.com/p/xpelair-ct4s-12w-simply-silent-contour-bathroom-extractor-fan-with-timer/7185f I can't find anything in the instructions regarding a delay to run up.

Thanks Derry. So the fan doesn't need to go back?

Good morning all, Just want to make sure it's not me missing something before I take this fan back. I've wired the ceiling fan in my bathroom to a pull cord as I didn't want it to come on whenever the kids put the light on in the toilet through the night, and when I switch the fan on, there is...

Thanks flame. I was looking at coming straight out of the flat roof but my concerns were I had this roof replaced last year and is now a GRP flat roof. How would you cut it without it cracking and how would you seal it from the elements? Surely not just silicone?

Good Evening All, I'm just in the middle of re-doing my bathroom due to a recent bedroom extension. (the fan did go on the outside wall but that is now my 4th bedroom!) The roof above is flat and I really don't want unsightly ducting in the bathroom. Anyway, I was wondering I may have room if...

Ronseal?

Ok thanks. I didn't see any instructions. What do you recommend? This is the door

Veneered I think

Good mornin all, I have recently bought some oak doors and was wondering what is the best thing to protect them? I was just going to buy some oil but as the doors cost a fair bit, I wanted the best varnish/stain/oil to protect and maintain their appearance. Regards

Cheers Dan. I'll get it later and let you know. Removing the old one from the old machine look a right ball ache!

I took the kids of the new machine but didn't want to force anything until I asked. Would that part from Screwfix work?

What that man says!!

I may have found it. Would this work?

good afternoon all, Right they maybe some simple solution to this but my new washing machine has turned up with a different drain hose than the one I removed. Is there an adapter or something or do I need to replace the whole thing? I had a Bosch and replaced it with a Bosch. Many thanks

Of course! :mrgreen: Seriously though, if anyone reads this with the same problem, I would defo recommend to only attempt if brave enough. The plate was a right bar steward to get out!!

Many thanks for all your help. I decided to go for it and have a look. I've been inside it before so just planned on having a look around. In the end I removed the plate and cleaned it out. There were loads of little black bits came out when flushed. I then opened something that looked like a...

Dan, Roger that mate. Are these things a DIY job to replace? I'm pretty competent with a spanner...... And hammer should I need it!