Search results

I have held the switch in by hand and still no reset. I installed the alarm and have not changed any default passwords. I have not been able to find any reset info in the engineers manual.

Thanks for your reply It says control panel case tamper, I can hear the switch clicking when I put the control panel on I just cant get the message to clear. the unit is only a few weeks old.

Hi I would appreciate any help to reset a control panel tamper alarm on my pyronix enforcer control panel. I put the alarm in engineer mode and opened the control panel and when I closed it up I have the tamper alarm and I can't reset it. I have searched through the programming manual with no...

Thanks for your reply, I will do as you suggest.

Hi, the towel rail in my bathroom needs bleeding every few days, I assume that is because it is the highest on the system. I have tested the gas that bleeds off as suggested in other places on the forum and it is Hydrogen, or at least its flammable. I have read on the forum that this is caused...

Hi I am in the proccess of fitting a new kitchen and was wondering about the best place to put the radiator. the kitchen is 4.5m x 3.5m and on one wall I have a space between the wall and a tall cooker housing which is about 1m wide, I would like to fit a vertically mounted rad in this corner...

Thanks for your answers, I will try your suggestions and see how it goes.

There used to be inhibiter in but I had to drain the system about 1 year ago and never put more back in, I will put some in and see if it makes a difference. Can it make so much gas in such a short time? and what part exactly is likely to be corroding?

Hi, I have a towel warmer/radiator in my bathroom and the problem is it needs bleeding around once a month. Because of its shape it is the highest rad on the system. When I bleed the air out it's fine but within a month the top third is cold again. Can anybody tell me why this may be happening...

Thanks for your help, now I know what to get a quote for.

I havn't got the ovens yet but I think in the shop it said 16a supply. I will get an electrician to do the job but need to know the requirements so that I get the job done right. Will that mean two circuits from the consumer unit with 2.5mm cable?

Yes I will use the existing cooker supply for the hob but will need a supply for the ovens. Could they both ovens be run from one supply?

Hi I am fitting a new kitchen and will be having a 3.7kw built in single oven and a 3.2kw grill/microwave combi built in oven, I will also have a hob which I intend to connect to my existing cooker supply. Can you please tell me what type of supply I need to have fitted for for these...

Hi I have had ceramic floor tiles on my conservatory floor for 12 years, the floor was asphalt originally. I would now like to lift these tiles and replace them with a wood floor. My question is are they likely to come up easily and am I likely to damage the asphalt in doing so. thanks

Thanks for your answers, I can't see any difference between them.

I have been looking for some internal french doors and have seen advertised pattern 10 and pattern 20 doors, to me they look just the same. Can anyone tell me what the difference between the two is please.