Search results

Many thanks for that information, much appreciated.

Got ya, it's the symbol, lines following the 4 5v. Sorry about that, thanks again.

Or is that It in the model number? Thanks for your reply.

Can see the 4.5v but no DC.

Hi All, a small query, could this be removed and replaced with a 3 pin plug as we only require the steady mode, I can't see anything about it being DC output, many thanks in advance.

How can I run this cable directly down into conservatory? It's gonna be for fibre broadband, less bends the better. As it is now it goes under the flashing and down between house and added conservatory. Many Thanks Brian.

OK, thanks very much, advice much appreciated.

With the tiling I was just concerned about the tile adhesive sticking to the wood, many thanks for your reply.

Hi folks, can you offer any advice on the following. I'm planning on tiling kitchen floor but there is a trench containg 2 x 15mm copper pipes, the top of the trench is finished off with a wooden board. What's best to protect these pipes so I can remove the wood and cement over before tiling...

Thanks for your reply.

Thanks for your reply.

Hi all, I looking to fit a battern light onto a ceiling that's been cladded with upvc, I've attached the type of lamp I'm planning on. Which is the best way to connect to the mains? I was thinking of a lighting wago box pushed up behind the ceiling behind the light. These fittings have flex pre...

I've just removed a very old cooker back box from a kitchen wall. The wall is a Thermalite cavity structure, on removal of the box I'm left with a gaping hole that goes right into the cavity. How do I make this good please? Was thinking of patching in with Thermal Insulation Board, leaving...

Thank you for your reply.

Thank you very much for your prompt reply.

Random question, I'm renewing a Cooker switch and a Cooker outlet plate, neither of the back boxes are not earthed (both metal). It states in some q&a there's no need to earth the back box. 6.00mm Cooker cable has an earth of 2.5mm, could I use a length of 2.5mm cable stripped of it's...

Thanks for that, that was the option I took, worked a treat. Thanks to all replies I received, much appreciated.

Hi all, currently have a 100mm hole in thermalite block, what's the best way to increase this to 150mm (for a cooker hood)? 1. I've read to stich drill and chip away 2. Cut away with Pad Saw I thought of cutting square, insert round pipe and make good in the 4 corners. Any advice appreciated...

Ah right, I'm with you now, thanks for your time, much appreciated.

So can both cables use the bottom entry option? Thanks for your reply.