Search results

  1. T

    Dimmer switch for low voltage spots

    Hi, I have two banks of low voltage spots. Each bank of the kitchen/diner has - 10 spots each with a 50w bulb on its own switch. Total of 500 watts each bank I would like to now if there is a twin dimmer switch available that can cope with this or do I have to reduce the bulds to 30w...
  2. T

    Wood worm spray?

    Hi, I am replacing a floor and some joists as they have had woodworm in places - I plan to remove all traces of wood and sweep out the sub floor - Is there a spray that you can get to spray any remaining joists to ensure the worm is killed off? Thanks in advance
  3. T

    Consumer unit in a downstairs toliet?

    Hi, My consumer unit is currently over our back door. Next to the back door is downstairs toliet/sink room. I want remove the back door and block up the opening and replace it with a window. I would then remove the wall and turn the door to the toliet around so the downstairs toliet takes the...
  4. T

    installing shower tray in ensuite

    The joists run across the room so I wont havr to cut a joist I can run the pipe straight out the wall.
  5. T

    installing shower tray in ensuite

    Hi, I have a shower tray in the main bathroom which is on adjustable legs with a skirt covering the void. I am about to install a shower tray in an ensuite and really would like to have the tray on the floor rather than having to step up into the shower. Obvously you need to get to the...
  6. T

    running ch and h/cw pipes in kitchen behind units

    Hi, I am having a forth bedroom/kitchen extension built and its got the plumbing stage of the build. I am having a galley style kitchen with two straight runs each side of units. I have to take the CW main up the one wall in the corner over the ceiling and back down to the sink area I also...
  7. T

    Does it make a difference which side the feed goes on a rad

    Hi, Does it matter which side the feed is connected to on a radiator. I assume that the thermostat valve is always fitted on the feed side is this correct or doesn't it matter.
  8. T

    Hiding pipes in brick?

    I have just channeled in some pipes to a shower mixer valve and this was only have way up a wall - if you are going all the way up to the ceiling you have a long hard job chiseling out!!
  9. T

    end filling a leaking presolder joint

    whats the easiest way to get the joint apart - heat it and then use pliers to prize apart or cut the joint off and start again?
  10. T

    end filling a leaking presolder joint

    thanks guys - I will try one more resolder and then its a new joint.
  11. T

    end filling a leaking presolder joint

    Hi, I have changed a load of of piping today with loads of new joints but have suffered with one leaking when I turn the ch heating on. Its a 22mm tee joint - i thought I had held the blow torch on long enough as I could see solder but its leaked. I drained down the system and then tried to...
  12. T

    plastic or copper pipe?

    Hi, I have had a kitchen/bedroom extension built and I am just get prices for the plumbing work. I have been asked by my plumber if I want copper or plastic pipe - which is the best and which is the most expensive - I assume copper?. I want the CH extended into the new bedroom/ensuite and the...
  13. T

    LG TDC70040E Tumble dryer not turning

    do you know the easiest way to get the side off? - Do you have to remove the front panel?
  14. T

    LG TDC70040E Tumble dryer not turning

    Hi, I have had an LG tumble dryer for two years and as soon as its out of warranty by days it breaks down. The dryer switches on as normal - select cycle etc and then press start. - the dryer buzzes and the motor moves very slightly one way and then the other and then nothing. I have took...
  15. T

    French doors opening 180 degrees

    Hi, I want to install some french doors into an new extension and have them open outwards onto the side walls so they would have to open 180 degrees. The window firm sdaid they could do this but would potentially mean the frame not covering the cavity gap fully and the this would have to be...
  16. T

    Roof window to give light and ventilation to bedroom below

    Thanks for the reply - Would it really leak heat? - dont all roof windows leak heat then? Yes there are going to be french doors opening onto a juliet balcony and a small window in the ensuite bathroom but the reason why i am looking at a roof window is to give us more ventilation without...
  17. T

    Roof window to give light and ventilation to bedroom below

    Hi, I am building a forth bedroom extension with a pitched roof joining onto the existing roof. The current loft space is boarded and not tall enough to stand up in. My question is can I install a roof window and make a frame work down into the bedroom below, plaster board the frame work...
  18. T

    French doors - fixed open setting

    I havent got them yet but plan to have plastic. Yes we have lots of *****'s around here (out in the country) but I dont plan leaving the doors open when I go out. Alarm and killer cat will protect the house anyway!
  19. T

    French doors - fixed open setting

    Hi, Can you get French doors that you can open slightly like you can with windows. We are having french doors in a new kitchen extension but there wont be any other windows to open so I want to be able to open the french doors slightly for ventilation. The doors will have trickle vents but we...
Back
Top