Search results

They wont talk to the public. Said they don't repair.. Will just make sure I don't buy one of their alarms.. Very unhelpful. Thanks for everyone's help here. (y)

will do.. hope they are open to talking to the public.

Hi, Thanks for the reply.. Even with the Dip switch in place the codes don't reset.. I am expecting that following restoring power it should go through the initial setup.. But this doesn't seem to happen, the codes don't reset.. Is it possible to reset it via the programming interface...

Hi All, Moved in a new home. House has a Risco Lightsys alarm installed, but with no external bell and missing a couple of sensors. I have purchased these and have gone to fit them. I'm wanting to set the alarm back to defaults. I looked up in the manual how to reset the "defaults". Setting...

many thanks :)

There are no 2.2k resistors, these are Red Red Red? So I will also need some 4.7k resistors..? The manual does just show 2.2k across alarm and tamper.. (Page 28) But as you said it also shows 4.7k for ID 13

Thanks... So there is nothing limiting me just to RISCO sensors? Believe the value is 2.2k @12v

Hi all, Is it possible to use the Pyronix MEQ Blue Quad PIR Detector with a LightSYS2 alarm. The LightSYS supports wired sensors, but is lacking any connections for tamper. So being an armature at this it looks to me like I should use Double End of Line resistors so the LightSYS can see the...

Thanks.. Any info will help... Just looking for what i can use with this alarm..

risco is embossed in the plastic.. It was installed 18 months back..

Thanks for the reply: I believe it is a hardwired Panel, but all the room zones are wireless, and just the doors are wired. The receiver is this version: https://www.riscogroup.com/products/category/repeater if that helps.

Sorry if this has been asked before... New house, New alarm but looking for details on it.. Understand that this is a wireless alarm, and from what I can see there are 6 wireless zones, the door contacts are wired. There is also single wired control panel.. My question is, is this alarm...

flameport & RogerBoyle Thank-you - Will go for a 450 unit and reuse the doors.. I have looked around for 600 units but there are none that are free or with in a run on the drain.. Will remove the doors, collapse the 900 unit, remove it and then fit a 450 unit, fit the dishwasher in the gap...

On a kitchen unit carcass is it possible to move over centre post? This would be preferable as it would allow the reuse of the 2 x 45 cm doors.. ( yes there would be some cutting) of the shelves involved Assumed for Jackrae reply i would have to remove the units and rebuild..

ok. new location needed

thanks for the reply.. so remove the 900 install a 400 wide unit on the left. leaving a gap to the right ... for the dishwasher. But then the door wont fit on the unit on the left thanks again.

Just buying a new house, want to fit a Dishwasher, managed to grab a few pics on a walk around.. (Power, water, drain are all just out of the pic to the right of the second pic.) There is a unit around 90cm wide.. With 2 x 45cm doors opening out from the centre. Here you can see the left side...

There is nothing when the timer is set for both. If I manual move the leave to override the ch kicks in. If I then make a call for hw I hear nothing If its just hw the valve moves.