Search results

Mine is leaking on the join where the plastic elbow is attached to the hose- reason I think it is due to strain when it comes out - it does get pulled taut sometimes - to clean behind I need to just pull it out and push it sideways -hose isn't long enough for me to pull it straight out far...

Ok seeing as no one has said don't do it (and it is out of any guarantees etc anyway) bog standard cheapo it is then ! Thanks!

I have a leak on my cold infill hose for my Bosch Washing machine - looked at Bosch ones - £18ish :eek:. Could get a standard one for £3 ish and it is longer than the Bosch which in my situation might be better as when I pull it out to clean under it (rarely ;)) it does strain the hose a bit...

Can't find the instructions at the moment ...actually came across them quite recently and put them somewhere safe but can't remember where right now... :oops: - will check in the shed again tomorrow in the daylight...and post them if I find them But I think it was easy - disconnect the...

Hi It looks just like the photos for another machine in a previous post ...but this is mine as well - click on the image to see the larger version... - grey arrows show where the catches are you put your finger in the hole and pull toward the front. As a PP poster said - I find doing one...

Hmmm that is really really rubbish .... This is a replacement for an Ikea tap that was 4 or 5 yrs old. The valves went, were replaced then the handle started spinning on the valve spindle ...and they don't do new handles (and had discontinued that tap) They were very good, it was still under...

It's a monoblock tap and the spout became so stiff that it loosened the tap on the sink. I've managed to tighten up the tap underneath but obviously the spout is going to need to be cleaned and greased otherwise it'll happen again. Problem I have is I can't get it apart. Have found the...

No replies :( Maybe more info would help? I've managed to get the side panel off - found part of the top 'water inlet' full of crap -mainly greasy crud, but had a sliced mushroom in there too... It is in a small reservoir thing around a valve (not attached to any sensors etc but has a...

Thanks I'll ask if he bled it ...would think so but you never know...

Just asking for advice really...is this a coincidence or ? So a (gas safe reg) plumber installed a new hw cylinder attached to a 6 yr old worcester bosch greenstar 30cdi boiler. Just a slightly bigger vented tank. Day after boiler develops a fault...a U9. First on CH only, then on HW. Now...

So started today - did a load and it didn't seem to have cleaned properly (had oven rack shelves in so no top shelf - thought one of the trays had stopped the powder dispenser opening properly) -turned it on again and at the end of the cycle it was making a churning noise but not emptying...

Need to replace the blades on my 2005 Zafira and have discovered 'flat' blades. For £5 or so more than conventional ones I can get retrofit flat ones... are they that much better? Is it worth it? Not too worried about fuel consumption - only do low mileage - more interested in whether they...