Search results

whats your day job? i would asume that you earn more in the day than a labrador or electrical improver but £60 a week and carrying all the tools is all part of the apprentaship bro i worked in tesco at night to do my course in the day for 6 months, then jumped on with a builder, and then...

ive been working for my self for 4 years after leaving a big firm. im a bit fed up with the money hassle and worries, and am starting on a new build site on price. any advice...?????? do i need a bogie,what tools are esential??

probably lookin 700 ish obviously depends on the job fining down is more time consuming dashing may be the way to go

i got mine soon too havent got a date yet :oops:

robin kts 1620 multifunction current operated elcb and measuring continuity from neutral incoming on to the main earthing conductor to the rod

not really a problem with the socket under the sink as it is not in contact with water or likely to become in contact unless a unforseen problem accurs ie trap leaks. you should have queried this with the contractor if you were concerned. also at the bare minimum you should have a completed...

ive got a tt system, ive installed 2 rods reading 74 ohm neutral to earth and i'm getting 63 ohms at the furthest light, and similar on any other circuit . can't get pme everything is bonded the board is covered by a wylex earth leakage circuit breaker and a 30ma rcd what do i do

it was a b&d 14.4v in the dewalt radio charger i took it back and exanged it i just want someone to tell me they been doing it years and mine was coincidence

i want to deck the back of the van out, ive got wood on the floor and i want to rack up one side to hold my boxed drills and stuff, any advice greatfully recieved its a vito by the way

3 weeks old. i dont know what to do

im in the same boat i dont know what to do either

YES it was all going so well!!!! i don't rush to take my dewalt out of the radio charger when they are charged, and have never had a problem, but now im thinking i done the same with the b&d and possibly broke it, i don't know whether to carry on

anyone use a dewalt charger to charge b&d batteries, mine fit and i have been doing it for a while , and one fo the batts broke, i dont know if i overcharged it,

theres your answer then m8 don't do any additional work thats not required by regs no matter how safe i would do it and i would take a link to other pipework. so that every exposed metal part is at the same potential but don't buy more cable if youve run because as the guys said its...

the way i look at it,is if a potential was raised on say the hot tap , it would be live , yes you touch it create a circuit if it is bonded the current would flow through the bonding straps/earth cable to earth causing the overcurrent device would operate eliminating the potential...

if you look around for a transformer phone chargers etc check the wattage is same, cut off the jack (with the juice off) and solder + and - to the correct terminals on the appliance adding speakers probably need an amp ???

ALL extraneous CONDUCTIVE PARTS MUST BE BONDED TO THE MAIN EARTHING CONDUCTOR therefore all metalwork in the bathroom should be bonded also a strap from your copper flow or return up on to the rad is required if you are going all out a link between light fitting and shower/shaver point to...