Search results

Thank you both for your help and advice … will replace the trap !

Ahh that makes sense … so the black ring that fell out was just a bit of the inbuilt black rubber part! Is the inbuilt rubber part replaceable, or is that screw on part with the rubber inside still available to buy? If not I will buy the tape and do as you suggest. Again, thank you.

Yes, the black inside the base part is like a solid rubber liner .. the shiny bit at the bottom is just water. The seal that fell,out looked exactly like the new seal but broken. I will buy some tape and try that. Hopefully I can then remove the bucket ! Thank you very much for your help.

I have attached a couple more photos. The top part does not have a shoulder, just thread. Hopefully the photos will explain my problem.

Many thanks for your reply Apologies for my idiocy but this is totally new to me, am amazed I actually cleared the sink blockage. The O ring that fell out looks identical to the replacement, I thought it had to be. 32mm … are there smaller sizes and should the O ring fit halfway down inside the...

Having had a blocked kitchen sink, I removed the trap and a broken small round washer fell out. I had a replacement 32mm washer, more like a rubber band but not stretchy, but it seems too large to fit inside the bottom trap part that screws onto the pipe. Advice would be appreciated !

Thank you !

Thank you for that. They are stamped Nisco 22 864 so I assumed they are 22mm ?

They do look a bit grim but the rust is actually superficial and not eaten through.

I have just had a quote for removal of the asbestos - £220 plus VAT

These are also extremely old and lots of them - best for scrap ?

Thank you again - may try Ebay and emphasise that it is not to current regs.

Many thanks - will give it some thought !

Can anyone tell me if this huge and heavy isolator (probably 40 plus years old) is usable or is it scrap ? Dimensions are: 25" high x 18" wide x 10" deep 3 Phase 440V and neutral. 200 Amp. Imperial is embossed into body.

Does this cable conform to current regs or should it be scrapped ? I have 3 full reels and two almost full - 4 x red and 1 black.

Many thanks - might be easier to open a yuppy bar in situ. The quantity is pretty much as in the photo - are these styles and sizes still used or are they obsolete or not to standard ? If obsolete will probably scrap them then but as mentioned, seems such a terrible waste.

Many thanks. Unfortunately I need to sort them within a few weeks - I just don't want to scrap something that is unused if it has a use. Seems such a waste.

I have attached photos of various items (excluding the reels of cable) - all unused - and want to know if they are usable - currently in use - or obsolete and only fit for scrap. Any help would be appreciated.

Oh - the 1 1/2" on the outside of the box is for the saddle type (middle picture above) - I don't know the internal diameter of that. The F42 with the internal dia. of 2" are in the first picture above. I did see the unlined steel clapms when I was searching but they have a different base...