Search results

What size undersink water heater is advisable for one sink. 10 or 15 litres? Thanks

Can any of the under sink water heaters be wired to a plug? I know can get 2 and 3 kw ones.

Has anyone had issues with a pressure reducing valve causing water hammer, can the springs go in them?

Have fitted a few stone resin shower trays on sand and cement. A weak mix the floor and shower tray both primed with SBR bond. What the best procedure when dealing with the lightweight shower that aren't stone resin. Is 1200x900 quadrant. Thanks for your thoughts

I have a solvent waste pipe to run for a basin. Due to space restraints upsizing to 40mm solvent is difficult. The pipe terminates in to a hopper. The total length would be around 4meters.. Anyone had to do similar before. Or likely to cause issues?

What's best to first fix the waste pipe for a vanity basin like this? Is it to run it the wall and elbow out?

Which it the best of these two products

Are the hep2o isolation valves ok installed on C/H. I no the cheap brass ones leak from the o-rings after time. Thanks

I have a new toilet to connect to a 3 inch cast stack. It used to have a toilet connected on it before via Lead pipe. Would most recommend a new stack or connecting on to the 3 in branch of the stack collar. And converting to plastic.

When doing a bathroom. Do you usually fit the shower tray before or after plasterering?

If swapping this tap would you swap the isolation for a iso with a flat face. And the elbow for an elbow that is 15mm comp to 1/2" male?

If a kitchen tap is dripping ceramic disc cartridge. Is it worth taking the tap apart to clean/regrease the cartridge?

Could a shape dent in black lino be concealed with black stixall?

That Syphon is splittable so I can replace the split washer. With out having to remove the cistern?

Have a low level toilet with the waste pipe exiting through the floor. I plan on using a bent pan connector into it. However the connector is still too far back to fit the flush pipe. Is there an extension peace I can put in to the bend pan connector to allow the toilet to be for further forward?

Is there anyway of repairing/making less obvious a dent/scratch in black lino? Thanks

Do I need to cut the ends off new copper pipe with a pipe cutter before crimping. Or can I use it straight out of the bundle without trimming the ends?

Why do column radiators have baffles in them? I no you need to flow to the side with the baffle can anyone explain there function please

I'm looking at swapping 2, 1100 wide by 500 heigh single panel converter radiators for two tower column radiators. The existing are about 890 watts each. The columns will be 440 wide 1800 heigh a single in those are 850watts. A double is 1250 watts. Would I be best of with the double column or...

This